OPERATION | |||
CASE FRONT CONTROLS (See Figure B.1) | Connector for a remote control. |
| |
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
1. Left DISPLAY window
Shows WIRE FEED SPEED or AMPERAGE.
2. Left KNOB
Adjusts values in left display.
3.Right Display window Shows VOLTAGE or TRIM.
4.Right Knob
Adjusts values in the right display.
5. Status LED
Illuminates a steady green when communicating to the power source properly.
6.IR port
Used to transfer information to palm computers, etc.
7.MSP4 display window
Shows detailed welding and diagnostic information.
8.Left Button
Changes the MSP4 display to show the Weld Mode or Arc Control.
9. Right Button
Changes the MSP4 display to show Start Options or End Options.
10. Set Knob
Changes the value on the MSP4 display.
11. ON/OFF switch
Controls power to the POWER FEED® 25M.
12. 5-pin connector
Trigger connector for a
13.
14. 7- pin connector Connector for a
15. Cover
Covers location for optional water cooling line.
16. Set-Up
Lights when feeder is
17. Memory Panel Door
(See Memory Panel Operations in this Section)
FIGURE B.1
1 |
|
2 | 3 |
| |
5 | 4 |
| |
6 | 7 |
| |
8 | 16 |
| |
10 | 9 |
| |
11 |
|
12 | 14 |
| |
13 | 15 |
|
Return to Section TOC
Return to Master TOC
17
Fold Out
Memory Panel