Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING AND REPAIR | ||||
Observe Safety Guidelines detailed in the beginning of this manual. |
|
| ||
|
|
|
|
|
PROBLEMS |
| POSSIBLE AREAS OF | RECOMMENDED |
|
(SYMPTOMS) |
| MISADJUSTMENT(S) | COURSE OF ACTION |
|
|
|
|
|
|
|
| FUNCTION PROBLEMS |
|
|
The wire feed speed is consistent | 1. The DIP switch on the wire drive | 1. The feed head control | board | |
and adjustable, but runs at the | unit may not be set for the correct | may be faulty. |
| |
wrong speed. |
| gear ratio. See the Installation |
|
|
|
| section of this manual. | 2. The wrong gear may be installed. | |
|
|
| ||
The unit shuts off while welding or | 1. The drive motor may be over- | 1. If there are no restrictions in the | ||
attempting to weld. The STATUS | loaded due to a mechanical | wire feeding path, the drive | ||
LED is alternating between red and | restriction in the wire feeding | motor or gear box may be faulty. | ||
green every second. The unit tries | path. See Operation section of | 2. The feed head control board | ||
to recover after 30 seconds and | this manual. | |||
may repeat sequence. |
|
| may be faulty. |
|
|
|
|
|
|
|
|
|
|
|
CAUTION
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact the Lincoln Electric Service Department for technical troubleshooting assistance before you proceed. Call