Samsung 7100 Mounting Control Boards, Setting Switches and Mounting Option Boards

OfficeServ 7100 Installation Manual

3.2 Mounting Control Boards

This section describes how to set the switches of MP10/11 control board, mount the option boards, insert to the slots and connect MP10/11 board.

3.2.1 Setting Switches and Mounting Option Boards.

MP10/11 has the switches to set the board operation for the user’s purpose and fitting with the system configuration. The way to set the switches and mount the boards are as follows:

1)Set S1 switch of the MP10/11 board as On and Pin 1 to Pin 4 of S2 switch as Off. Pin 6 to Pin 8 are set depending on the user’s purpose.

S2

On

			S1	Off
			Off
			On
		Figure 3.2 Setting Switches of MP10/11 Board
		Table 3.3 Switches of MP10/11 Board
Switch			Description
S1	Set S1 as On before mounting on the slot for memory backup.
	If switched On when the switch is Off. all data in the database are automatically
	initialized. To store the data in the database, operate the system after turning on the
	S1 switch.
S2	SW1~SW4		the pins are set the country code that the system will be used.
	SW6~SW8		Sets the number of digits for C.O./extension lines and extension.
			[ Not-used : Always default 3 digits ]
			SW6-On: 4 digits for C.O. line
			Off: 3 digits for C.O. line
			SW7-On: 4 digits for an extension group
			Off: 3 digits for an extension group
			SW8-On: 4 digits for an extension number
			Off: 3 digits for an extension number

© SAMSUNG Electronics Co., Ltd. 3-3