CHAPTER 3. Ошибка! Стиль не определен.
3.3 Mounting Interface Boards
This section describes how to set jumpers and switches of an interface board, how to mount optional boards to an interface board, and how to mount interface boards into slots.
3.3.1 Setting Switches and Mounting Optional Boards
These interface boards are divided into the boards to set switches or jumpers and the boards to mount option boards.
Table 3.5 Interface Board for Switches/Jumper Setting
Interface Board | Jumper/Switch Setting | Jumper/Switch Function |
TEPRI | S1(SW1~SW8) | Setting E1, T1/E1/PRI, 24B+D/24B, |
|
| User/Network and 17H/13H |
TEPRI2 | S2(1~4) | Setting T1, E1, T1/E1,PRI, 24B+D/24B, |
| S3(1~4) | User/Network and 1AH |
TEPRI(a/2) Cards is only support E1(1) PRI function, but not supports for
E1(T1) Digital Trunk function.
Table 3.6 Interface Boards that can mount option boards
Interface Board | Option Board |
MP10(MP11) | 4DLM or 4SWM, MODEM |
|
|
UNI | 4TRM, 2BRM, 4DLM, 4SLM |
|
|
4SWM Module board supports not 10M LAN interface but 100M LAN interface. 4TRM Module board supports not Dial Pulse dialing but DTMF dialing. 8TRK Card supports DTMF and Dial Pulse dialing
© SAMSUNG Electronics Co., Ltd. |