Operation / Maintenance and cleaning / Disposal / Information
jPlace the belt sander on to the mounting frame 12 and guide the dust extraction spout 5 through the opening of the mounting frame 12. Tighten the screws 16.
jPlace the two clamp plates 13 on to the holes provided on the opposite side and screw the clamp plates tight with the provided screws.
jInsert the pins of the screw clamps 14 into the holes on one of the long sides of the mounting frame 12 (see Fig. E). Attach the mounting frame 12 by tightening the screw clamps 14.
Sanding vertically (see Fig. F):
jInsert the pins of the screw clamps 14 into the holes on one of the short sides of the mounting frame 12. Attach the mounting frame 12 to a flat, stable surface (e.g. workbench) by tighten- ing the screw clamps 14.
jInsert the two spacer plates 15 into the holes provided for them on the supporting surface of the mounting frame 12. The tapers must narrow towards the outside (see Fig.).
jPlace the belt sander on to the mounting frame 12 and guide the dust extraction spout 5 through the opening of the mounting frame 12. Tighten the screws 16.
jPlace the two clamp plates 13 on to the holes provided on the opposite side and screw the clamp plates tight with the provided screws.
The belt sander is designed to be maintenance-free.
jClean the device frequently. This should be done immediately after you have finished using it.
jUse a dry cloth to clean the device - never use petrol, solvents or cleaners that attack plastic.
jAlways keep the ventilation slots clear.
jRemove any adhering dust with a narrow paint brush.
QDisposal
The packaging is wholly composed of
Do not dispose of electrical power tools with the household rubbish!
In accordance with European Directive 2002 / 96 / EC (covering waste electrical and elec- tronic equipment) and its transposition into national legislation, worn out electrical power tools must be collected separately and taken for environmentally compatible recycling.
Contact your local refuse disposal authority for more details of how to dispose of your worn out electrical devices.
QTips and tricks
jNever use the same sanding belt to sand wood and metal.
jWorn or ripped sanding belts can damage the workpiece. Change sanding belts at the appropriate time.
jKeep the sanding belt properly tensioned so that it does not hang down too much and become unusable due to nicks, creases etc.
QMaintenance and cleaning
Warning! Before you carry out any work on the belt sander always pull the mains plug out of the mains socket.
QInformation
QService centre
The service centre for your country is shown in the warranty documentation.
JHave your device repaired only by qualified specialist personnel using original manufacturer parts only. This will ensure that your device remains safe to use.
JIf the plug or mains lead needs to be replaced, always have the replace- ment carried out by the manufactur- er or its service centre. This will ensure that your device remains safe to use.
GB/IE/CY 13