Conair Servo Traveling Saw
Operator Control Instructions
R e t u r n S o f t k e y
Pressing the soft key located under the word Return on the
ENTER TABLE RETURN
SPEED 1200 . 00 ipm .
Table area screen. Selects the Table Return Speed screen. The number shown is the current return speed in inches per minute. A cursor will appear in the least significant digit. The user has a choice of ways to adjust this number. The
acceptable range is 120.00-1800.00 ipm
Exit or Prev- if no change is required press Exit or Prev to return to the Table area screen.
Raise will increase the preset by 10.00 imp. The key can be pressed once for each 10.00 ipm increment required or held down to scroll up. Releasing the key will freeze the preset at the last value.
Lower will decrease the preset by 10.00 ipm. The key can be pressed once for each 10.00 ipm decrement required or held down to scroll down. Releasing the key will freeze the preset at the last value.
Numeric keys
Key in the speed required and press enter. The decimal place is fixed so remember this when entering the preset. If you require 1200 inches per minute you must key in 120000 and then press enter. Keying only 1200 will set the speed to 12.00 inches per minute and the out of range warning will appear on the screen for 5 seconds.
Enter or Delete?
If the keyed in number is correct press the enter key for it to be accepted and return to the Main screen. If it is wrong press the delete key and the previous preset will reappear.
Appendix