Bosch Power Tools GTS1031 manual ATTACHINg the ANTI-KICKbACK dEVICE

BM 2610014415 01-11 E:BM 2610012089 12-10 E 1/10/11 7:17 AM Page 13

10.Lower the front of the guard assembly 4 until the metal “fork” is parallel with the table (Fig. 8).

11.Press down on the guard release lever 5 until you feel and hear it snap into the locking posi- tion. Check that the guard assembly is securely connected (Fig. 8).

ATTACHINg THE ANTI-KICKbACK dEVICE

12.Attach the Anti-Kickback Device 7 into the flat re- cessed area 8 of the riving knife 2 (Fig. 9).

13.Squeeze the compression pads 9 while nesting the device into the flat area (Fig. 9).

14.Release the compression pads such that the Anti-Kickback Device locks onto the riving knife

immediately behind the guard assembly. Check that the attachment pin is securely connected into locking hole. Carefully raise and lower the pawls 10 – when letting go, the spring-loaded pawls must come down and contact the table in- sert (Fig. 9).

Hint: Position the Anti-Kickback Device behind the flat recessed area and slide it towards the front until it drops into the recessed area – then release the com- pression pins.

Note: The two attachments are independant of each other, so the Anti-Kickback Device can be attached before the Guard Assembly.

4	FIG. 8
	5

FIG. 9 7 9

9

10

8

2

-13-