Assembly
Unpacking and Checking
Contents
!CAUTION Before moving the saw: Lock the miter lock knob in 45° left or right position. Lock
bevel lock handle. Lock head assembly in the down position.
Never carry the tool by the cord or head assembly power switch handle. Damage to insulation could cause an electric shock. Damage to wire connections could cause a fire.
Model 3912 Compound Miter Saw is shipped complete in one box.
1.Separate all parts from packing materials and check each one with the “Table of Loose Parts” to make sure all items are accounted for before discarding any packing material.
2.Loose parts:
•Quick Action Clamp - Used to clamp
•Hex Wrench - Should be stored on the left rear base.
•Blade Wrench - Should be stored in the handle.
•Miter Lock Knob
•Dust Chute Elbow
•Dust Bag
•Operating/Safety Instructions
!WARNING If any parts are missing, do not plug in power cord or turn the switch on until the
missing parts are obtained and are installed correctly.
Installation of Miter Lock Knob
1.Locate Miter Lock Knob from Loose Parts.
2.Assemble Miter Lock Knob into front of Table as shown (Figure 1).
Do Not Over Tighten
5
FIG. 1
15
10
5
0
5
10
28