DM 2610000602 05-08 5/19/08 9:35 AM Page 15
To replace a band on the Drum Sander, loosen the screw without removing it to contract the drum then slide the old band off. Slide the new sanding band on and then expand the drum by tightening the screw once again.
! WARNING | Before each use, check to | |
make certain that all compo- | ||
|
nents are assembled to accessory shank and that the drum is sufficiently expanded to secure the band during use. If sanding band is loose on the drum during operation it may “fly” off and strike you or bystanders.
Maintenance
Service
!WARNING NO USER SERVICEABLE PARTS INSIDE. Preventive mainte-
nance performed by unauthorized personnel may result in misplacing of internal wires and compo- nents which could cause serious hazard. We recommend that all tool service be performed by a Dremel Service Facility.
D.C. motors
The motor in your tool has been engineered for many hours of dependable service. To maintain peak efficiency of the motor, we recommend it be exam- ined every six months. Only a genuine Dremel replacement motor specially designed for your tool should be used.
Cleaning
! WARNING | To avoid accidents, always dis- |
| connect battery pack from tool |
|
before cleaning. The tool may be cleaned most effectively with compressed dry air. Always wear safety goggles when cleaning tools with com- pressed air.
Ventilation openings and switch levers must be kept clean and free of foreign matter. Do not attempt to clean by inserting pointed objects through opening.
Certain cleaning agents and ! CAUTION solvents damage plastic parts.
Some of these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents, ammonia and house- hold detergents that contain ammonia.
15