specific SAFETY RULES
Know your pneumatic tool. Read operator’s manual carefully. Learn its applications and limitations, as well as the specific potential hazards related to this tool. Following this rule will reduce the risk of electric shock, fire, or serious injury.
Always wear eye protection with side shields marked to comply with ANSI Z87.1 along with hearing and head protection. Failure to do so could result in objects being thrown into your eyes and other possible serious injuries.
Protect your lungs. Wear a face or dust mask if the operation is dusty. Following this rule will reduce the risk of serious personal injury.
Protect your hearing. Wear hearing protection during extended periods of operation. Following this rule will reduce the risk of serious personal injury.
Make sure the hose is free of obstructions or snags. Entangled or snarled hoses can cause loss of balance or footing and may become damaged.
Use the tool only for its intended use. Do not discharge fasteners into open air.
Use the pneumatic tool only for the purpose for which it was designed.
Use only the fasteners recommended for this tool. Use of the wrong fasteners could result in poor fastener feeding, jammed fasteners, and nails leaving the tool at erratic angles. If fasteners are not feeding smoothly and properly, discontinue their use immediately. Jammed and improperly feeding fasteners could result in serious personal injury.
Never use this tool in a manner that could cause a fastener to be directed toward anything other than the workpiece.
Do not use the tool as a hammer.
Always carry the tool by the handle.Never carry the tool by the air hose.
Do not alter or modify this tool from the original design or function without approval from the manufacturer.
Always be aware that misuse and improper handling of this tool can cause injury to yourself and others.
Never clamp or tape the trigger or workpiece contact in an actuated position.
Never leave a tool unattended with the air hose attached.
Do not operate this tool if it does not contain a legible warning label.
Do not continue to use a tool that leaks air or does not function properly.
operation
Always assume that the tool contains fasteners.
Do not carry the tool from place to place holding the trigger. Accidental discharge could result.
Always handle the tool with care:
•Respect the tool as a working implement.
•Never engage in horseplay.
•Never pull the trigger unless nose is directed toward the work.
•Keep others a safe distance from the tool while tool is in operation as accidental actuation may occur, possibly causing injury.
Choice of triggering method is important. Check manual for triggering options.
Pneumatic tools are designed for
Do not point the tool toward yourself or anyone whether it contains fasteners or not.
Do not actuate the tool unless you intend to drive a fastener into the workpiece.
Always ensure that the workpiece contact is fully positioned on the workpiece. Positioning the work contact element only partially on the workpiece could cause the fastener to miss the workpiece completely and result in serious personal injury.
Do not drive fasteners near edge of material. The workpiece may split causing the fastener to ricochet, injuring you or a
Keep hands and body parts clear of immediate work area. Hold workpiece with clamps when necessary to keep hands and body out of potential harm. Be sure the workpiece is properly secured before pressing the nailer against the material. The workpiece contact may cause the work material to shift unexpectedly.
Keep face and body parts away from back of the tool cap when working in restricted areas. Sudden recoil can result in impact to the body, especially when nailing into hard or dense material.
4 - English