GLOSSARY OF TERMS
Activate (operating controls)
To move an operating control so that it is in a position that allows the tool to be actuated or that satisfies one requirement for the tool to be actuated.
Actuate (tool)
To cause movement of the tool component(s) intended to drive a fastener.
Air inlet port
In an air tool, the opening to which the compressed air supply is connected, usually by means of a threaded fitting.
Fastener
A staple, pin, brad, nail, or other fastening device which is designed and manufactured for use in the tools within the scope of this standard.
Jam
An obstruction in the feed or drive areas of the tool.
Maximum air pressure
The maximum allowable pressure of the compressed air, as specified by the manufacturer, for operating a tool.
Operating control
A control that separately, or as part of an actuation system, can cause the actuation of a tool.
Single sequential actuation
An actuation system in which there is more than one operating control and the operating controls must be activated in a specific sequence to actuate the tool. Additional actuation can occur when a specific operating control, other than a workpiece contact, is released and
Trigger
A tool operating control activated by a tool operator’s fingers.
Workpiece
The intended object into which a fastener is to be driven by a tool.
Workpiece contact
An operating control element or assembly on the tool intended to be activated by the material to be fastened.
7 - English