OPERATION
WARNING:
Do not allow familiarity with tools to make you care- less. Remember that a careless fraction of a second is sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could re- sult in objects being thrown into your eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not recom- mended by the manufacturer of this tool. The use of at- tachments or accessories not recommended can result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
Drilling in wood
Drilling in ceramics, plastics, fiberglass, and laminates
Drilling in metals
Mixing paint
This product will accept Ryobi One+ 18 V
For complete charging instructions, refer to the Operator’s Manual for the battery packs and chargers listed in the General Safety Rules.
TO INSTALL BATTERY PACK
See Figure 2.
Place the direction of rotation selector in center position.
Place the battery pack in the drill. Align raised rib on bat- tery pack with groove in drill’s battery port.
Make sure the latches on each side of the battery pack snap in place and that battery pack is secured in drill before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the drill and latches into place properly. Improper installa- tion of the battery pack can cause damage to internal components.
BATTERY PACK
LATCHES
DEPRESS LATCHES TO |
|
RELEASE BATTERY PACK | Fig. 2 |
TO REMOVE BATTERY PACK
Place the direction of rotation selector in center position.
Locate latches on side of battery pack and depress both sides to release battery pack from the drill.
Remove battery pack from the drill.
9