Delta 22-590 instruction manual HOW to Adjust the Infeed and Outfeed Tables

8.Take this time also to clean the rollers (I) Fig. 22A.

9.Your unit is equipped with double-edged knives. If the second edge of the knife has not been used, rotate the knife 180 degrees and replace on the cutterhead. Replace the knives if both sides have been used.

10.Attach the hold-down bar (F) Fig. 21 that you removed in STEP 4. Tighten all fasteners securely.

11.Depress the cutterhead lock release and rotate the cutterhead to the next empty position until the cutterhead lock engages.

12.Repeat steps 9 through 11 to replace the other knives.

13.Reattach the cutterhead guard or dust collection attachment.

A	C
B
Fig. 19	Fig. 20

Fig. 21

D

E

F

HOW TO ADJUST THE INFEED AND OUTFEED TABLES

Your unit has been factory set to eliminate snipe. If your unit loses its adjustment and causes snipe, you can adjust the infeed and outfeed tables to minimize this condition.

1.Place a dime (A) Fig. 23A at each end of the platen (infeed and outfeed).

2.Place a straight edge (B) across the two dimes. Extend the straight edge past the leading edge of the infeed and trailing edge of the outfeed tables.

3.If your tables are properly adjusted, the straight edge will touch both of the dimes and the edges of the tables (Fig. 23C).

4.If your table needs adjustment, loosen the locknuts (A) Fig. 23B on the table height-adjustment screws (B). Adjust the screws up or down to achieve the desired table height.

5.Make sure that both height-adjustment screws contact the bottom of the table after adjustment.

G

H

Fig. 22

I Fig. 22A

B

A

Fig. 23A

B
A
Fig. 23B	Fig. 23C
13