Delta 78-055B Attaching Accessory Drawer to Extension Table, Attaching Handle to Drawer

ATTACHING ACCESSORY DRAWER TO EXTENSION TABLE

If you have the accessory drawer, remove the drawer (H) Fig. 5 from the drawer frame (I). To do this hold release tab (J) and unhook the drawer’s metal glider from the frame’s metal glider.

Turn drawer frame (I) upside down (as shown in Fig. 6) and line up four holes in drawer frame — two shown at

(K)Fig. 6 — with the four holes (L) Fig. 7 in the bottom of the extension table.

Attach the frame to the bracket using four 1/4-20 x 1/2” (13 mm) hex socket button head cap screws and 1/4-20 flange nuts. Insert the screws down through hole (K) Fig. 6 and tighten underneath with flange nut.

NOTE: Do not re-insert drawer until the table is turned right side up and attached to the saw.

i

H

J

Fig. 5

ATTACHING HANDLE TO DRAWER

Hold the drawer handle (N) Fig. 7A up to the holes (M) and attach handle to the drawer face with two #8-32 x 1-1/2” (38 mm) round head screws (not shown).

L

Fig. 7

M

Fig. 7B

DRAWER STORAGE FOR ACCESSORIES

The drawer (P) Fig. 7C can hold several blades and many of the accessories that come with your Unisaw.

I

K

Fig. 6

M

N

Fig. 7A

P

Fig. 7C

7