HP 350 500, How to Read the Scale, Cut the top of this chart along, Dashed line, Select parameter

TOP

1

4

CUT HERE

FEED THIS END FIRST TOP

								5
950	850	750	650	550	450	500	600	700	800	900
				CALIBRATION VALUE SCALE						6
SET-UP											How to Read the Scale					640
	Cut the top of this chart along the															620
1												630
	dashed line.
												610
2	Enter the “Change Parameter” menu and											630	530		580	680
	select parameter 200.											610	510		560	660
	a) note existing value:											590	490		540	640
												570	470		520	620
	b) enter new value:									1500	650	550	450	500	600	700
												CALIBRATION VALUE SCALE
MEASUREMENT
3 Exit the Service Menu and
	a) set Copy Reduction to: 100%										Moving from the left side to the right
	b) set Resolution to: FINE										side, the scale increments by 10 for
											each scale tick mark (20 between
4	Load this sheet (after the top portion										tick marks on the same side). The
	is removed) into the FAX document										highest readable value in this
	feed tray (print side down, top end										example is 640.
	first).				Make one copy.

CALIBRATION

5Look at the copy and find the top most tick mark of the Calibration Value Scale which is visible.

6Determine the Calibration Value corresponding to this tick mark. See “How to Read the Scale”.

7Enter this value at parameter 200 location using the “Change Parameter” menu. Calibration is complete.

4-4Calibration and Adjustment