GE 6100, 4100 manual Framing for Wall Case, Brick Veneer and Frame Construction

26

FRAMING FOR WALL CASE

Brick Veneer and Frame Construction

MAIN STUD	HEADER – 4" x 4" OR
JACK STUDS	2 - 2" x 4" ON EDGE

16-1/4" MIN. RAB71A

16-1/2" MIN. RAB77

ADJUSTABLE FRAMING TO SECURE

THIS DIMENSION

42-1/4" MIN. (RAB71A)

42-3/8" MIN. (RAB77)

JACK STUD CRIPPLE

FINISHED FLOOR

SUB-FLOOR

Note: Do not remove the stiffener support from inside the wall case until the chassis is to be installed.

Figure 1

FASTENING WALL CASE

MAIN STUDS

HEADER

JACK STUD

LINTEL

MOUNTING

SCREW HOLE

Framing detail for this construction is as shown in Figure 1. Note use of lintel under first course of brick above the Zoneline case. Do not use the case as a lintel. Mounting screw holes shown are to be made by the installer.

NO HOLES PERMITTED IN BOTTOM OF CASE (EXCEPTION -RAD10

DRAIN KIT)

	WOOD	MOLLY	EXPANSION
	SCREW	OR TOGGLE	ANCHOR
		BOLT	BOLT
	NO HOLES PERMITTED IN
2" MIN.	BOTTOM OF CASE
	(EXCEPTION - RAD10
	DRAIN KIT)		Choice of attachment devices
	JACK STUD		through both ends of case or the
			top. Mounting screw holes and
			attachment devices by installer.

MAIN STUD

Figure 2