Installation Instructions
2 INSTALLATION (cont.)
7INSTALL THE INDOOR UNIT
•Route the tubes and wiring from the right side of the indoor unit . Cut off the tailings from the chassis as necessary.
1.Cut off tailings 1 when routing the wiring only.
2.Cut off tailings 1 and 2 (or tailings 1, 2 and 3) when routing both the wiring and tubing. 1 and 2 below are the recommended tubing.
1 Right tube
2 Right rear tube
7INSTALL THE INDOOR UNIT (cont.)
•Wrap the tubes and wiring and pull them through the
Wrapping tape |
| |
Connection tubes |
| |
Power | Control cord (for | |
cooling/heating | ||
connection cord | ||
type only) | ||
|
Drainage hose
•Hang the mounting slots of the indoor unit on the upper tabs of the mounting plate and make sure it is firm enough.
Tailings 3 Tailings 2
Tailings 1
•The height of the installed location should be 79″ or more from the floor.
13