Installation Instructions
Mini Split-System Air Conditioners
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•IMPORTANT — Save these instructions for local inspector’s use.
•IMPORTANT — Observe all governing codes and ordinances.
•Note to Installer – Be sure to leave these instructions with the Consumer.
•Note to Consumer – Keep these instructions for future reference.
•Skill level – A licensed, certified (to handle refrigerant- R410A, recovery, etc.) technician and a qualified electrician are required for installation of this split
air conditioning system.
•Completion time – Approximately 21⁄ 2 hours
•Two people are required to install this unit due to the weight of the product .
•Proper installation is the responsibility of the installer.
•Product failure due to improper installation is not covered under the Warranty.
•For personal safety, this system must be properly grounded.
•Protective devices (fuses or circuit breakers) acceptable for installation are specified on the nameplate of each unit .
•Servicing and installation of the refrigerant system must be performed only by a licensed,
•Make sure to avoid wiring or plumbing inside the wall when installing.
•For any service which requires entry into the refrigerant sealed system, Federal regulations require the work be performed by a technician having a Class II or Universal certification.
ELECTRICAL REQUIREMENTS
•Be certain all wiring complies with local building codes and NEC and that the supply voltage for this system is correct. The system supply voltage is connected to the outdoor unit only.
•Check the rating nameplate on the side panel of outdoor unit for required circuit protection rating and required supply voltage.
•Use
•All wiring should be rated appropriate for the current value listed on the rating plate.
•Be certain there is an uninterrupted, unbroken electrical ground connection.
•Wiring should be encased in
CAUTION:
•Do not use an extension cord with this system.
•Aluminum building wiring may present special
•When the unit is in the STOP position, there is still voltage to the electrical controls.
•Disconnect the power to the system before servicing by removing the branch circuit fuses or turning the circuit breakers off at the panel.
•DO NOT use equipment certified for R22 refrigerant only.
8