ALARM OUT
Each ALARM input corresponds to one of the 3 ALARM OUT. < The ALARM3 is designed as the Relay OUT >
ALARM PATTERN
This sets the operation of PATTERN movements when inputting ALARM.
When the ALARM is inputted the correspondence will be as follows: ALARM1 input to PRESET 1, ALARM 2 input to PRESET 2, ALARM3 input to PRESET 3, ALARM 4 input to PRESET 4, and MOTION input to PRESET 5.
When the ALARM is working, it will stay in the PRESET location corresponding the ALARM for the DWELL TIME and the ALARM connected to the PATTERN will continuously operate the PATTERN movements.
ALARM OUT
ALARM1 1
ALARM2 2
ALARM3 3
ALARM4 2
MOTION 1
EXITQUIT
ALARM PATTERN
ALARM1 OFF
ALARM2 OFF
ALARM3 1
ALARM4 2
MOTION 3
EXITQUIT
OTHER SET
AC(Auto Calibration)
This function turns on or off Auto Calibration.
You may set to OFF/6HOUR/12HOUR/18HOUR/24HOUR. Without user’s key input for the time designated by the user, A.C. will appear on the screen while initializing LENS and PAN/TILT.
P.P/T(Proportional PAN/TILT)
This function controls the PAN/TILT speed to the ZOOM magnification ratio during the manual operation of PAN/TILT. If you set PROPORTIONAL P/T to ON, the PAN/TILT speed will increase in the ZOOM WIDE mode and decrease in the ZOON TELE mode even in the same manual operation.
HOME RETURN
When there is no KEY input or other movement for a certain time, the camera moves to the HOME location automatically. The HOME location can be assigned from the HOME POSITION menu.
SET UP TIME FOR HOME RETURN:
E
The OFF in the Setup Menu does not operate the PATTERN, and it means 1
PATTERN1, | 2 PATTERN 2, | 3 | PATTERN 3, continuous motion of HALF1 |
PATTERN 1 | + PATTERN 2, continuous motion of HALF 2 Pattern 2 + PATTERN 3 | ||
and continuous motion of FULL |
| PATTERN 1+PATTERN2+PATTERN3. | |
OFF: HOME RETURN function cancellation
OFF ➞ 1 MIN ➞ 2 MIN ➞ 3 MIN ~ 60MIN ➞ ~12HOUR 
HOME POSITION
AUX OUT CONTROL
This sets the ALARM OUT motion to continue or act only when the ALARM is working.
If it is set to OFF the ALARM OUT motion will operate only when the ALARM is set off (Active "Low"), and if it's set to ON, the ALARM OUT will always operate regardless of the ALARM.
AUX OUT CONTROL
OUT1 OFF
OUT2 OFF
OUT3 ON
EXITQUIT
You can select the HOME POSITION from the preset positions numbered between 0 and 127.
AUTO FLIP
When operating the Tilt to the 90° limit using the Joystick, the camera PAN automatically revolves 180° showing the opposite area of the Tilt area.
It gives the effect of extending the Tilt operating area 180°.