Samsung AF0AKV3SAEENSG manual Deciding on where to install the product

INSTALLATION PARTS

Deciding on where to install the product

•Install the outdoor unit in a place where water can drain smoothly.

––If you cannot find a place satisfying above conditions, please contact manufacturer. Make sure to clean the sea water and the dust on the outdoor unit heat exchanger and spread corrosion inhibitor on heat exchanger. (At least one time per one year.)

•Choose a place where there is no direct sunlight.

•Choose a place where it could not come into contact with snow and rain.

•Choose a place where flammable gas does not leak.

•Choose a place where the indoor and outdoor unit can be connected with a pipe.

•Choose a place where there is no direct sunlight.

•Choose a place where it could not come into contact with snow and rain.

•Choose a place where flammable gas does not leak.

•Choose a place where the indoor and outdoor unit can be connected with a pipe.

WARNING

•After installing the outdoor unit, apply rust inhibitor on the internal pipes and heat exchanger.

––If you don’t apply rust inhibitor, airborne corrosive gas (such as sulfur compounds, hydrogen sulfide and ammonia) and salty dust may cause pipe corrosion which will lead to refrigerant leakage.

––Inspect the outdoor unit at least once a year and re-apply the rust inhibitor where it is damaged (worn out).

•When applying the rust inhibitor, please be aware of the following: ––Turn off the power before spraying the rust inhibitor.

––Wear protective goggles and mask before spraying.

––Clean the dusty surface with clean fabric or paper before spraying. ––Make sure that wind is blowing from worker’s back when spraying. ––Do not spray on the PCB panel and electric parts.

36English