Samsung AF0AKV3SAEENSG manual Troubleshooting, Problem Solution

Troubleshooting

Refer to following chart if the air conditioner operates abnormally. This may save time and unnecessary expenses.

PROBLEM	SOLUTION
	• Check power status and then operate the air conditioner again.
The air	• Check whether the power plug is connected correctly or the auxiliary
conditioner does	power switch is switched on.
not work at all.	• If the air conditioner is switched off by the Timer function, press the
	On/Off button.
The temperature	• Temperature adjustment is not available when the Fan mode is
adjustment is not
	selected.
working.
Fan speed	• Check if you have selected Auto/Dry/Turbo mode. In these modes,
adjustment is not
	fan speed is set to Auto and you cannot adjust the fan speed.
working.
	• Replace the exhausted batteries with new ones.
Remote controller	• Do not block the remote controller receiver.
	• If the remote controller is used near strong light(3-wavelength
does not work.
	fluorescent light, neon sign etc.), the remote controller may not work
	due to the electronic jamming signal
	• Check if the set temperature is higher than the current temperature.
	Press the Temp + or - button on the remote controller to set the
	temperature lower than the current temperature.
	• Check if you have selected Fan mode. In this mode, Cool air will not
	come out in Fan mode therefore select Auto/Cool/Dry mode.
	• Check if the air filter is blocked by dirt. If there is a lot of dust on the
	Air filter, cooling performance may decrease. Clean them frequently.
Cool air does not	• Check if the outdoor unit is covered or installed near the obstacle.
	Take the cover off and take the obstacle away.
come out of the
	• Check if the indoor unit is installed in a place with direct sunlight.
air conditioner.
	Close the curtain or blind to cover the sunlight.
	• If the doors or windows are open, it may cause bad cooling
	performance. Close the doors and windows.
	• If the air conditioner has just been turned on or the indoor
	temperature reaches the desired temperature, only fan will operate
	around 3 minutes for the product protection.
	• Check if the pipe length is too long. When the pipe length exceeds
	maximum allowable pipe length, cooling performance may decrease.

USING PARTS

English 27