Samsung AF0AKV3SAEENSG manual How to connect your extended power cables

How to connect your extended power cables

1Prepare the following tools.

Tools	Crimping pliers	Connection sleeve (mm)	Insulation tape	Contraction tube (mm)
Spec	MH-14	20 x Ø 6.5(HxOD)	Width 19mm	70 x Ø 8.0(LxOD)
Shape

INSTALLATION

2As shown in the figure, peel off the shields from the rubber and wire of the power cable.

•Peel off 20 mm of cable shields from the pre-installed tube.

CAUTION

•For information about the power cable specifications for indoor and outdoor units, refer to the installation manual.

•After peeling off cable wires from the pre-installed tube, insert a contraction tube.

3Insert both sides of core wire of the power cable into the connection sleeve.

•Method 1

––Push the core wire into the sleeve from both sides.

•Method 2

––Twist the wire cores together and push it into the sleeve.

(Unit: mm)

Power cable

20 20 20

60 120

180

Pre-installed tube for the power cable

20

Connection sleeve

Connection sleeve

PARTS

4Using a crimping tool, compress the two points and flip it over and compress another two points in the same location.

––The compression dimension should be 8.0.

––After compressing it, pull both sides of the wire to make sure it is firmly pressed.

Compression	• Method 1	• Method 2
dimension	Compress it 4 times	Compress it 4 times

5mm 5mm

74English