Samsung SSA-S2000 Forced Initialization with External Line, Hardware Forcible Initialization

FORCED INITIALIZATION WITH EXTERNAL LINE

1.Turn off the product, shortcircuit between the green line and the orange line with white stripes, and turn it back on.

2.When the initialization is completed, 3 LED indicators are blinking with a beep.

X Y Z

[\ ] ^ _ `

lzj W lu{

iŒ““

zzhTzYWWW

12V

GND

Green

Orange with white stripes Connect (Short-

circuit)

INITIALIZATION

3.Restore the connection of the two lines back to their original state.

HARDWARE FORCIBLE INITIALIZATION

This is to initialize the product forcibly by disassembling it.

Use this method only if you have lost the Master Card or the password, or if the forcible initialization with the external line failed.

1.Turn off the product and detach it from the installation site, then loosen the screw (x4) on each corner to disassemble it as shown.

2. Apply power to the product and short-circuit the jumper for		Connect
	(Short-circuit)
one second as shown.

3. When the initialization is completed, 3 LED indicators are blinking.

4. Turn off the product and restore it to the original installation state.

English _ 17