Samsung SSA-S2000W Basic setup, Duress Alarm, To Specify the Retry Count for AN Unregistered ID

basic setup

DURESS ALARM

If you are forced to open the door under the control of a criminal such as a robber, enter the predefined password with the number of your registered card (or PIN), which outputs the emergency TTL signal.

1.Present the Master Card to the device.

2. Press Button 2 and Button 9 in sequence and press ENT .

3.Enter the two-digit Duress code and press ENT .

•The default code is set to “00”. However, the number “77” can not be used because it is set for the Secure mode.

X	Y	Z
	\	]
		`
tˆš›Œ™Gjˆ	W
lzj		lu{
™‹
iŒ““
		zzhTzYWWW
X	Y	Z
[	\	]
^	_	`
lzj	W	lu{
iŒ““
		zzhTzYWWW

TO SPECIFY THE RETRY COUNT FOR AN UNREGISTERED ID

You can specify the retry count for authentication with an unregistered card or PIN.

If the retry count exceeds the set limit, the keypad input will be suspended for the next one minute. (You can specify the keypad input suspension time in “To specify the keypad input suspension time if the retry count with an unregistered ID exceeds the limit” on page 25.)

1.Present the Master Card to the device.

2. Press Button 8 , 2 and Button ENT in sequence and press ENT.

3.Enter the two-digit retry count and press ENT .

•You can specify a number from 00 to 99.

•The retry count for an unregistered ID is defaulted to “05”.

X	Y	Z
	\	]
		`
tˆš›Œ™Gjˆ	W
lzj		lu{
™‹
iŒ““
		zzhTzYWWW
X	Y	Z
[	\	]
^	_	`
lzj	W	lu{
iŒ““
		zzhTzYWWW

24_ Basic Setup