Samsung SSA-S2000W user manual Troubleshooting, √ RF Only

troubleshooting

Problem		Action
I can not register an additional user card	1) Check if the product is installed properly and works normally.
(or PIN).	- In the initial setup of the product or after it is initialized
	Set the operation mode and register the Master card and user cards as usual
	because the product is in the initial state.
	cSSA—2000 modes available : Mode Number + ENT
	√ RF Only	: 01 + ENT
	√ RF + P/W	: 02 + ENT
	√ PIN Only	: 03 + ENT
	√ RF or PIN	: 05 + ENT

dMaster Card (or (PIN): 4 ~ 6 digits (Mode 03 or 05) + ENT)

eEnter the user card or PIN number and provide the password according to the mode

fMaster Card (or (PIN): 4 ~ 6 digits (Mode 03 or 05) + ENT)

√For more information about registering the Master Card and the user card, refer to the initial setup section in the user manual.

2)If this happens when you try to register an additional card in normal operation mode

-Register the user card only as the Master Card is already registered.

cMaster Card (or (PIN): 4 ~ 6 digits (Mode 03 or 05) + ENT)

dCommand for an additional card registration according to the operation mode

√ RF Only	: 11 + ENT
√ RF + P/W	: 12 + ENT
√ PIN Only	: 13 + ENT
√ RF or PIN	: 15 + ENT

eEnter the user card or PIN number and provide the password according to the mode

fMaster Card (or (PIN): 4 ~ 6 digits (Mode 03 or 05) + ENT)

√For more information about registering the user card, refer to the additional user registration section in the user manual.

3)If the problem persists after you have followed the procedures above, contact a designated service center.

46_ Troubleshooting