reader mode setup
READER MODE SETUP (RF/PIN COMBINATION MODE)
No Master Card or Master PIN is ever registered.
If you remember the Master Card or the Master PIN was registered, initialize the product and try again.
1.When you turn on the product, all of the 3 LED indicators will flash with a beep.
•No flashing of the 3 indicators denotes that the reader mode is already specified.
2. Press Button 0 and Button 5 in sequence and press ENT .
3.Present a card that you want to register as the Master Card to the device. When the Master Card is registered, only the red LED indicator flashes.
4.Present cards or PIN numbers
to register the cards right now, simply jump to Step 5 above without through Step 4 above.
5.Present the registered Master Card to the product once again.
6.The device enters Standby mode with only the orange LED indicator flashing.
X Y Z
[\ ] ^ _ `
lzj W lu{
i
zzhTzYWWW
X | Y | Z | Î | X | Y | Z | or |
[ |
| ] | [ | \ | ] | ||
|
| ||||||
|
| ` |
| ^ | _ | ` |
|
tGj | W | lu{ |
| lzj | W | lu{ |
|
lzj |
|
|
|
| |||
i |
|
|
| i |
|
|
|
|
| zzhTzYWWW |
|
|
| zzhTzYWWW |
|
X Y Z
[\ ] ^ _ `
lzj W lu{
i
zzhTzYWWW
Î
X Y Z
[
]
t |
|
Gj | W lu{ |
i |
|
| zzhTzYWWW |
ENABLING KEYPAD INPUT FOR THE CARD NUMBER
Ensure that you must have registered the Master Card.
1.Present the Master Card to the device.
2. Press Button | 7 and Button 3 | in sequence and press ENT . |
• Repeat Step 1 above to release the specified mode, press Button 7 and | ||
Button 4 | in sequence, and press | ENT . |
tGj
X Y Z
\ ]
`
lzj W lu{
i
zzhTzYWWW
M You can set the device to allow you to control the door by entering the 8 digit card number using the keypad.
The default is “Keypad Input Disabled”.
X Y Z
[\ ] ^ _ `
lzj W lu{
i
zzhTzYWWW
20_ Reader Mode Setup