Samsung SSA-S2000W user manual 32 I/O Time Setup

I/O time setup

TO SPECIFY THE ALARM OPERATION TIME FOR AUX 2

1.Present the Master Card to the device.

2. Press Button 2 and Button 6 in sequence and press ENT .

3.Refer to the output port table on page 29 and specify a desired output mode.

•If you want the alarm relay alone to operate in normal and Secure modes in case of an input through the auxiliary port, select the

< 5 2 > buttons and press ENT .

4.Enter the two-digit door relay output time and press ENT .

5.Enter the two-digit alarm relay output time and press ENT .

6.Enter the two-digit TTL relay output time and press ENT .

•You can specify a two-digit time from 00 to 99 seconds.

•By default, all output times are set to “00”.

	X	Y	Z
		\	]
			`
tˆš›Œ™Gjˆ™‹	lzj	W	lu{
	iŒ““
			zzhTzYWWW
	X	Y	Z
	[	\	]
	^	_	`
	lzj	W	lu{
	iŒ““
			zzhTzYWWW

M Other output ports that are not specified for the output mode will not be activated. For instance, if you set the output mode to [5][2] and assign the operation time for each output device by following the steps 4, 5, and 6 above, only the alarm relay will operate.

TO SPECIFY THE ALARM OPERATION TIME FOR AUX 3

1.Present the Master Card to the device.

2. Press Button 2 and Button 7 in sequence and press ENT .

3.Refer to the output port table on page 29 and specify a desired output mode.

•If you want the alarm relay alone to operate in normal and Secure modes

in case of an input through the auxiliary port, select the < 5	2 >
buttons and press ENT .

4.Enter the two-digit door relay output time and press ENT .

5.Enter the two-digit alarm relay output time and press ENT .

6.Enter the two-digit TTL relay output time and press ENT .

•You can specify a two-digit time from 00 to 99 seconds.

•By default, all output times are set to “00”.

	X	Y	Z
		\	]
			`
tˆš›Œ™Gjˆ™‹	lzj	W	lu{
	iŒ““
			zzhTzYWWW
	X	Y	Z
	[	\	]
	^	_	`
	lzj	W	lu{
	iŒ““
			zzhTzYWWW

M Other output ports that are not specified for the output mode will not be activated. For instance, if you set the output mode to [5][2] and assign the operation time for each output device by following the steps 4, 5, and 6 above, only the alarm relay will operate.

32_ I/O Time Setup