Honeywell K14114 3/06 Rev.B setup guide Delete serial number

LYNXR-I Installation and Setup Guide

	83 Enhanced Sequential Mode
✻
			Serial number	This prompt can be used to enroll the transmitter serial number via
	Ib	zz	Enter transmitter’s 7- digit serial number via RF	RF transmission or manually. If using the RF Learning Mode there
				is no need to manually enter a serial number. Proceed directly to RF
			learning or manually.	Learning. Upon entering the Serial Number mode, the Zone
			[#] = return to (1A) prompt and reject whatever	Descriptors will be announced.
			serial number entries have been made.	Note: BR type devices can be enrolled only by transmission from BR
	Ib		[✻] = return to (1A) prompt (if a valid serial	devices. Likewise, UR and RF devices can only be enrolled by
			number has been enrolled, “L” is displayed	transmission from a UR or RF device
			and the serial number will be copied into	RF Learning - Two (2) transmissions (2 key depressions) at least
			EEROM and the last serial entered buffer.	five seconds apart, will be required for BR type or four (4)
				transmissions (fault, restore and fault, restore) for UR or RF type. If
			Note: For zones 26, 30, 34 and 38 only BR type	the learned serial number has a different loop number than that
				entered in ✻56 the system will announce the Voice Descriptor, if it
			devices can be used.
				is programmed, followed by two beeps and will return to Prompt (1A)
				and “L” will be displayed.
				If the loop number captured by RF transmission and that entered in
				✻56 mode match, the system will announce the Voice Descriptor, if it
				is programmed, followed by three beeps and return to Prompt (1A)
				and “LC” will be displayed. No additional transmissions are needed
				for confirmation.
				Manual Entry - Enter the 7-digit serial number printed on the
				transmitter. If you enter an incorrect digit, press the [#] key to
				backup to prompt (1A) and start over. When all 7 digits are entered,
				press the [✻] key. If less than 7 digits are entered, the keypad will
				emit a single long beep and return to the (1A) prompt without
				displaying the “L”.
				If more than 7 digits have been entered, the first 6 digits will be
				saved along with the last digit that was entered (entering 123456789
				yields the serial number 1234569).
				Note: If 52 seconds pass and no entry has been made, the system
				returns to prompt (1A).
			Delete serial number	This function deletes only the serial number.
	F
			0 = discard the delete request	Entering a “9” at prompt (1A). Confirmation of the delete request will
			1 = confirm requested delete	cause deletion of the serial number pertaining to the zone being
			Note: Entering a “9” at prompt (1A) will cause the	programmed.
			panel to return to prompt (1A) regardless of the
			confirmation answer.

Note: In Enhanced Sequential Learn Mode, 4 button type keys will always be learned simultaneously. They will be stopped at the 4 button boundaries of 26, 30, 34 and 38, provided the zone is free of a serial number. If the first zone of the key has a serial number learned, the remaining keys cannot be programmed in sequential learn mode. In addition, if the zone has not been set up (duplicate loop, missing zone type, etc.) only entries 0 (skip to the next zone) and 4 (copy the key template) will be allowed.

- 40 -