Honeywell K14114 3/06 Rev.B Keypad Functions, Message Center, Volume Control, Other Functions

LYNXR-I Installation and Setup Guide

System Operation

Keypad Functions

The keypad allows the user to arm and disarm the system, and perform other system functions, such as bypassing zones. Zone and system conditions (alarm, trouble, bypass) are displayed in the display window. When an alarm occurs, keypad sounding and external sounding will occur, and the zone(s) in alarm will be displayed on the keypad. Pressing any key will silence the keypad sounder for 10 seconds (only once). Disarming the system will silence both keypad and external sounders. When the system is disarmed, any zones that were in an alarm condition during the armed period will be displayed (memory of alarm). To clear this display, simply repeat the disarm sequence (enter the security code and press the OFF key). The keypad also features chime annunciation, and 3 panic key pairs for silent, audible, fire or personal emergency alarms. These keys can notify the central station of an alarm condition, if that service is connected. A summary of system functions is provided below for more detailed information refer to the User’s Manual.

Security Functions (Empty boxes represent the user’s security code)

Checking system status:

(high

level

messages); press

again for secondary

STATUS

STATUS

messages

To arm in STAY mode:

+

(or installer code + [3])

STAY

To restart exit delay:

(applies only if system is armed in Stay mode)

STAY

To arm in AWAY mode:

+

(or installer code + [2])

AWAY

To arm with NO DELAY:

+

or

+

AWAY

STAY

NO DELAY

To arm if Quick Arm is programmed:

or

(hold down for at least 2 seconds)

AWAY

STAY

To disarm the system and silence alarms:

+

OFF

Note: During Exit Delay or when an Alarm Condition exists the system can be disarmed by entering the User Code and entering the OFF key is not required.

To bypass a zone(s):
To turn Chime mode on or off:	FUNCTION

+

+

CHIME

BYPASS

+ 2-digit zone number(s)

Message Center
To record a message:	FUNCTION

To stop recording before end of 90 seconds: OFF

........................To play back a message:	FUNCTION
To skip a message:	[✻]
To delete all messages:
	FUNCTION

+

+

+

RECORD

PLAY

DELETE (during message replay)

Volume Control
To adjust message playback/system announcement volume:									+
							FUNCTION			VOLUME
To mute system announcements:		+			+
	FUNCTION		VOLUME				OFF
To restore/unmute announcement & volume:				+				+ [3] or [6]
		FUNCTION				VOLUME

+ [3] or [6]

Other Functions

To set the time and date: .......................

To set the scheduling: .............................

To activate or deactivate X10 devices 1-6:To activate or deactivate X10 devices 7 & 8: To add a user code: .................................

To delete a user code (except Master Code): To turn Test mode on: .............................

To turn Test mode off: ............................

+

+ [63]

FUNCTION

+

+ [64]

FUNCTION

+

or

+ device number

FUNCTION

LIGHTS ON

LIGHTS OFF

+

+

or

+ dev. No.

FUNCTION

LIGHTS ON

LIGHTS OFF

*+

+ user number + user’s code (*master code)

CODE

*+

+ user number (* master code)

CODE

+
	TEST
+	OFF

- 51 -