Honeywell K14114 3/06 Rev.B setup guide N t r o l, Smoke Detectors

LYNXR-i Installation and Setup Guide

					Troubleshooting Guide
C o n t r o l
		SYMPTOM			POSSIBLE CAUSE		REMEDY
1. The word “AC” is not				1a.	Interrupted AC power supply.		1a. Check transformer connection and
	displayed.						powerline circuit breaker.
2.	Digital communicator			2a.	System in Test mode.		2a. Remove from Test mode.
	message not being			2b.	Telephone connection not secure.		2b. Check all connections.
	received.			2c.	Digital communicator		2c. Check with a different CONTROL
					malfunctioning.		PANEL.
							2d. Program prefix or access code into the
				2d. Telephone number in program needs			CONTROL PANEL.
					prefix or access code.		2e. System cannot work in this situation.
				2e. Telephone call to central monitoring
					station requires operator assistance.
3. Does not arm properly.
	READY light not on.				Open or faulted zone(s)		Check for faulted zones and make intact,
							or use Bypass arming, if desired.
4. System doesn't respond to
	keystrokes on keypad.
	4a.	"CC" displayed.		4a. System is in communication with			4a. Wait until download session is
					downloader at central station.		finished.
	4b.	"d1" displayed.		4b. System has just been powered and is
					in its one minute initialization.		4b. Wait for initialization to finish, or
							bypass this time by pressing '#' + '0.'
Smoke Detectors
		SYMPTOM			POSSIBLE CAUSE		REMEDY
1.	Detector alarms, no		1a.	Dust, dirt in sensing chamber.		1a.	Clean unit's sensing
apparent reason.							chamber with vacuum
			1b.	Improper location.			cleaner per unit's
							instructions.
			1c.	Unit malfunctioning.		1b.	See unit's instructions
							for locations to avoid.
							Relocate as necessary.
						1c.	Replace detector.
2.	Detector's siren sounds.		2a.	Unit not receiving required power.		2a.	Check for proper
							installation of battery.
			2b.	Unit malfunctioning.			Try new battery.
						2b.	Replace detector.

- 61 -