INSTALLATION
OPTIONAL
BRICK PANELS
1)Open the bottom louver door. Loosen the 2 screws holding the Burner ON/OFF switch and bracket to the bottom louver and lift the assembly out.
2)Remove facade.
3)Remove glass door. Remove logs.
LOG SET
INSTALLATION
Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.
Log Kit #
4)Place Log 312 on the front right side of the burner, fi tting the log on the 2 pins.
312
Note: The logs must not be in the unit.
4)Insert the back brick panel fi rst by carefully slipping it between the back wall of the fi rebox and the rear log bracket.
5)Put the side panels in next. Slide them in from the front and push them fl at up against the wall. Be very careful not to scratch them on the fi rebox hardware.
6)Install the 2 brick retaining clips, one on each side.
a) | 306 | Rear Log | 5) Position Log 311 across the notch in Log |
b) | 307 | Middle Left Log | |
c) | 308 | Center Right Log | 306 and rest the bottom of the log into the |
d) | 309 | Middle Right Log | 2nd grate tab. |
e)310 Front Left Log
f)311 Center Left Log
g)312 Front Bottom Log
h) | Embers |
| |
i) | Vermiculite | 306 | |
|
| 311 |
306
307
Notch
3092nd Grate Tab
311
3086) Position Log 308 across the log landing in Log 311. Rest the bottom of the log against the 5th grate tab.
310312
The |
|
molded into the rear of each log. | 311 |
308
NOTE: If you will be installing the optional Brick Panels, install the Brick Panels prior to installing the logs.
Note: If the bottom brick panel must be removed: Remove the Rear Log Stand, then remove the Burner Tray. See the instructions in the "Removing Valve" section.
1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.
2)Sprinkle the vermiculite all over the top of the base brick panel.
3)Place Log 306 on the rear log support pins with the fl at side to the back.
306
Pins on the rear log support.
5th Grate Tab
7)Fit the bottom of Log 307 into the bracket on the left side of the burner.
307
Bracket
Excalibur® | 27 |