Excalibur electronic P95-NG3, P95-LP3 Picture below is a view from the back of the burner

INSTALLATION

8)Place the top of Log 307 across the notch on Log 311.

11)Fit Log 310 on the pin and then swing the front end of the log to hit the fi rst grate

12)Place the embers on the front of the burner tray.

306

311

307

310

Notch

Pin

9)PlacethebackofLog309againstthebracket on the top right side of the burner.

The picture below is a view from the back of the burner.

309

Rest log against

bracket306 Rear Log

311

Place embers on the burner tray.

DO NOT BLOCK BURNER HOLES

13)Test fi re to ensure proper light off (make sure fl ame fl ows smoothly from one end of burner to the other). If there is any fl ame hesitation, check that area for any blockage of the burner ports.

14)Reverse steps 1-3 under the "Optional Brick Panels" section.

307	309
Middle Left Log	Middle Right Log

10)Place the top of Log 309 on Log 308, supported by the knot.

309

308

Knot

310

Front Left Log

311	312	308
Center Left Log	Front Bottom Log	Center Right Log

28 Excalibur® P95-3 Zero Clearance Direct Vent Gas Fireplace