Excalibur electronic P95-NG3, P95-LP3 Accent KIT Installation, Single Door Accents

INSTALLATION

ACCENT KIT INSTALLATION

SINGLE DOOR ACCENTS

1)Remove the rivets from the surround by pulling out the hoseclamp with a screwdriver or plyer. Re-install the rivets by putting them through the holes on the sides of the surround.

2)Take the hoseclamps and put them over the back of each rivet. Squeeze the hoseclamp to secure onto rivets ensuring that the hoseclamp is touching the backside of thesurround.Thehoseclamp can now be released.

3)Remove the handles by removing the nut and screw. Install the new handles by placing them in position over the holes on the surround louver. Put the screws through the holes and secure them by tightening them with a nut.

4)Place the emblem over the emblem design on the surround. Insert the studs through the holes. To secure them fi rst put on the split lock washer and then the nut and tighten.

5)Remove the 2 studs on the sides of the Hood. Insert the new studs through the holes and secure them by fi rst putting on the washer and then tighten with a nut.

DOUBLE DOOR ACCENTS

1)Remove the handles by removing the nut and screw. Install the new handles by placing them in position over the holes on the door(s). Put the studs through the holes and secure them by tightening them with a nut.

30 Excalibur® P95-3 Zero Clearance Direct Vent Gas Fireplace