Windsor CBE20, CBCD20, CB20 manual Hazard Intensity Level, For Safety, When Servicing Machine

Page 6
HAZARD INTENSITY LEVEL

HAZARD INTENSITY LEVEL

The following symbols are used throughout this guide as indicated in their descriptions:

HAZARD INTENSITY LEVEL

There are three levels of hazard intensity identified by signal words -WARNINGand CAUTION and FOR SAFETY. The level of hazard intensity is determined by the following definitions:

WARNING - Hazards or unsafe practices which COULD result in severe personal injury or death.

CAUTION - Hazards or unsafe practices which could result in minor personal injury or product or property damage.

FOR SAFETY: To Identify actions which must be followed for safe operation of equipment.

Report machine damage or faulty operation immediately. Do not use the machine if it is not in proper operating condition. Following is information that signals some potentially dangerous conditions to the operator or the equipment. Read this information carefully. Know when these conditions can exist. Locate all safety devices on the machine. Please take the necessary steps to train the machine operating personnel.

FOR SAFETY:

DO NOT OPERATE MACHINE:

Unless Trained and Authorized.

Unless Operation Guide is Read and understood.

In Flammable or Explosive areas.

In areas with possible falling objects.

WHEN SERVICING MACHINE:

Avoid moving parts. Do not wear loose clothing; jackets, shirts, or sleeves when working on the machine. Use Windsor approved replacement parts.

Batteries emit hydrogen gas. Explosion or fire can result. Keep sparks and open flame away. Keep solution tank in raised position when charging. Keep sparks and flames away from the batteries. Do not smoke around batteries.

Disconnect batteries before working on machine. Only qualified personnel should work inside machine. Always wear eye protection and protective clothing when working on or near batteries. Avoid skin contact with the acid contained in the batteries.

Never allow metal to lie across battery tops.

2-2

86306300 CHARIOT BURNISHER 11/09/07

Image 6
Contents MODELS: CB20 Operating Instructions ENGiGLOSS CBCD20MODEL _______________________________________ MACHINE DATA LOG/OVERVIEWOVERVIEW DATE OF PURCHASE __________________________TABLE OF CONTENTS HOW TO USE THIS MANUALSAFETY HOW TO USE THIS MANUAL The PARTS LIST section contains assembled partslists include a number of columns of information SAVE THESE INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING THIS MACHINEIMPORTANT SAFETY INSTRUCTIONS must always be followed, including the followingWHEN SERVICING MACHINE HAZARD INTENSITY LEVELFOR SAFETY Never allow metal to lie across battery tops86244310 PRV NO. CAUTION LABEL 86243830 2 PRV NO. SAFETY LABEL LOCATIONPINCH CAUTION 86252520 PRV NO. BATTERY CAUTION 86306300 CHARIOT BURNISHER 11/09/07TECHNICAL SPECIFICATIONS DIMENSION/CAPACITYITEM TECHNICAL SPECIFICATIONS SPECIAL NOTESMEASURE HOW THIS MACHINE WORKS Filter Access Lid COMPONENTSControl Housing Control Panel-DriveDRIVE CONTROLS 86306300 CHARIOT BURNISHER 11/09/07DRIVE CONTROLS DRIVE CONTROLS 6.SPEED CONTROL SWITCH7.DRIVE RESET SWITCH 8.HORN BUTTON10.BATTERY CHARGE LEVEL INDICATOR- BASIC DRIVE CONTROLS11. HOUR METER-BASIC 3. Pad Pressure Meter 1. Pad Adjustment KnobBURNISHER CONTROLS 1 2 33-10 BURNISHER CONTROLS3.PAD PRESSURE METER EMERGENCY STOP PROCEDURES MACHINE OPERATION3-11 PRE-RUNMACHINE INSPECTIONINEFFICIENT BURNISHING PATH 3-12MACHINE OPERATION RECOMMENDED BURNISHING PATHMAINTENANCE MAINTENANCESERVICE SCHEDULE Check pad for proper installationBattery Connector-Machine MAINTENANCE-BATTERIESBattery Tray Battery Tray LatchBATTERIES MAINTENANCE-BATTERIESBATTERY MAINTENANCE Charge batteries in a well ventilated areaCHECKING GRAVITY A.Hydrometer B.Battery MAINTENANCE-BATTERIESCHECKING BATTERY SPECIFIC GRAVITY BATTERY CONDITIONMAINTENANCE-BATTERIES CHANGING BATTERIESBatteries are a potential environmental hazard MAINTENANCE 1.Dust Bag/Filter 2.Pads 3.SkirtsPAD INSTALLATION MAINTENANCEDUST BAG REPLACEMENT DUST CONTROL SKIRTSMAINTENANCE-PADDRIVER PAD DRIVER REPLACEMENTMAINTENANCE-PADDRIVER 3 7/8MAINTENANCE-SHUNTADJUSTMENT 4-10SHUNT ADJUSTMENT MAINTENANCE-DRIVEMOTOR & BRAKE 4-111.Drive motor 2.Parking brake 3.Drive chain ELECTRIC PARKING BRAKE ENGAGEMENT 4-12MAINTENANCE-DRIVEMOTOR & BRAKE To disengage brakeDRIVE MOTOR CARBON BRUSH REPLACEMENT 4-13MAINTENANCE-DRIVEMOTOR & BRAKE Do not use a pressure washer to clean around1.CIRCUIT BREAKERS MAINTENANCE-CIRCUITPROTECTION4-14 2.FUSETROUBLESHOOTING 4-15MACHINE TROUBLESHOOTING CONTROLLER FAULT CODES PROPEL CIRCUIT BOARD TROUBLESHOOTING4-16 4-17 MACHINE TROUBLESHOOTING CONTROLLER FAULT CODESPROGRAMMER LCD BURNISHER PARTS 86306300 CHARIOT BURNISHER 11/09/072 3 1 BUMPER10 1 7 6 6 86306300 CHARIOT BURNISHER 11/09/07BUMPER Page CONTROL PANEL CONTROLS & HOUSING CONTROLS & HOUSING PART NODECALS 86306300 CHARIOT BURNISHER 01/06/096 5 3 2 1 7 DECALS PART NO14 5 12 2 FILTER86306300 CHARIOT BURNISHER 11/09/07 10 6 13 7 15-10 FILTERFRAME-LOWER 5-1186306300 CHARIOT BURNISHER 11/09/07 5-12 FRAME-LOWERPART NO 1 2 3 2 FRAME-UPPER5-13 4 7 2 4 25-14 FRAME-UPPERPART NO 8 9 5 HOOD5-15 15 1 16 3 14 165-16 HOODPART NO PEDAL PLATFORM 5-175-18 PEDAL PLATFORMPART NO 2 11 14 5-19PEDAL PLATFORM 3 13 15 6 6PEDAL PLATFORM 5-20REAR COVER 5-2186306300 CHARIOT BURNISHER 011/09/07 5-22 REAR COVERDECK LIFT MECHANISM 5-23DECK LIFT MECHANISM 5-24DECK LIFT LINKAGE 5-255-26 DECK LIFT LINKAGEPART NO STEERING 5-275-28 STEERINGPART NO WHEEL-FRONT DRIVE-CHAIN 5-2986306300 CHARIOT BURNISHER 05/19/08 5-30 WHEEL-FRONT DRIVE-CHAIN20 19 18 16 WHEEL-FRONTBRAKE5-31 10 11 12 7 8 95-32 WHEEL-FRONTBRAKESERIAL NO WHEEL-FRONTDRIVE, GEAR 5-335-34 WHEEL-FRONTDRIVE, GEAR5-35 WHEEL-REAR1 2 86306300 CHARIOT BURNISHER 11/09/075-36 WHEEL-REARWIRING-BATTERIES 5-375-38 WIRING-BATTERIES5-39 WIRING-COMPONENTS1 3 5 7 6 8 9 13 11 86306300 CHARIOT BURNISHER 02/03/095-40 WIRING-COMPONENTSPART NO 3 LT BLU WIRING-CONTROLPANEL5-41 28 GRN5-42 WIRING-CONTROLPANELPART NO 1 WHT WIRING-DRIVEMOTOR5-43 2 BLK5-44 WIRING-DRIVEMOTORPART NO WIRING-MAINHARNESS 5-455-46 WIRING-MAINHARNESSDIAGRAM A 5 ORG 6 BRN 7 GRN 3 LT BLU 4 RED WIRING-PEDALPLATFORM5-47 DIAGRAM B 5 GRN 10 BRN 6 ORG5-48 WIRING-PEDALPLATFORMWIRING DIAGRAM 5-49SUGGESTED SPARE PARTS 5-50BACK-UPALARM - OPTION 5-5186306300 CHARIOT BURNISHER 11/09/07 5-52 BACK-UPALARM - OPTIONBATTERY CART - OPTION 5-5386306300 CHARIOT BURNISHER 02/12/08 5-54 BATTERY CART - OPTION5-55 BATTERY CART - OPTION86306300 CHARIOT BURNISHER 11/09/07 5-56 BATTERY CART - OPTIONPART NO 1 34 5 6 8 7 16 18 22 21 SEAT - OPTION5-57 2 14 12 11 9 15 205-58 SEAT - OPTION6REAR WARNING LIGHTS - OPTIONFRONT 5-595-60 WARNING LIGHTS - OPTIONPART NO 86306300 CHARIOT BURNISHER 11/09/07 55-97-611CBE20:100201000010, CB20: 100200800369, CB20X: SERIAL NUMBERS5-62 86306300 CHARIOT BURNISHER 12/16/08