Sears 139.53915D owner manual Install the Lights, Attach the Emergency Release Rope and Handle

Page 18

INSTALLATION STEP 7

Install the Lights

•Press the release tabs on both sides of lens. Gently rotate lens back and downward until the lens hinge is in the fully open position. Do not remove the lens.

•Install a 100 watt maximum light bulb in each socket. Light bulb size should be A19, standard neck only. The lights will turn ON and remain lit for approximately 4-1/2

minutes when power is connected. Then the lights will turn OFE

•Reverse the procedure to close the lens.

•Use A19, standard neck garage door opener bulbs for replacement.

To prevent possible OVERHEATINGof the endpanelor light socket:

•DO NOTuse short neck or specialty light bulbs.

•DO NOTuse halogenbulbs. UseONLYincandescent. To prevent damage to the opener:

•DO NOTuse bulbs larger than IOOW.

•ONLYuse A19 size bulbs.

100 Watt (Max)

Standard Light Bulb

Release Tab

NOTE: Use only standard light bulbs. The use of short neck or speciafity light bulbs may overheat the endpanel or light socket.

1O0 Watt (Max)

/

' jl

Lens

StandardHinge Light Bulb --

INSTALLATION STEP 8

Attach the Emergency Release Rope and Handle

•Thread one end of the rope through the hole in the top of the red handle so "NOTICE" reads right side up as shown. Secure with an overhand knot at least 1"

(2.5 cm) from the end of the rope to prevent slipping.

•Thread the other end of the rope through the hole in the release arm of the outer trolley.

•Adjust rope length so the handle is 6 feet (1.83 m) above the floor. Ensure that the rope and handle clear

the tops of all vehicles to avoid entanglement. Secure with an overhand knot.

NOTE: If it is necessary to cut the rope, heat seal the cut end with a match or lighter to prevent unraveling.

To prevent possible SERIOUSINJURYor DEATHfrom a failing garage door:

•If possible, use emergency releasehandle to disengage trolley ONLYwhen garagedoor is CLOSED.Weak or broken springs or unbalanceddoor could result in an open door failing rapidly and/or unexpectedly.

•NEVERuse emergency releasehandle unless garage doorway is clear of persons and obstructions.

•NEVERuse handle to pull door open or closed. If rope knot becomes untied,you could fall.

Trolley

Release

arm

 

Emergency

 

Overhand

 

Knot

Release

Handle

 

d

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents RRFTSMAN+I Contents IntroductionTools needed Preparing your garage doorSectional Door Installations Sectional Door InstallationPlanning ONE-PIECE Door Installations ONE-PIECE Door Without TrackONE-PIECE Door with Track Carton Inventory SECURITY,¥Assembly Hardware Installation HardwareHardware Inventory Assembly Step Assemble the Rail & Install the TrolleyInstall the Idler Pulley Fasten the Rail to the Motor UnitInstall the Belt and Attach the Belt Cap Retainer Readand Followall Installationwarningsand Instructions InstallationAssembly Step DeathInstallation Step Determine the Header Bracket LocationInstall the Header Bracket Wall Header Bracket InstallationCeiling Header Bracket Installation Attach Rail to Header Bracket Position the Opener Sectional Door or ONE-PIECE Door with TrackHang the Opener Opener, twist same color wires together. Insert wires into Install Door ControlConnecting Multiple Door controls Quick-connect holes white to white and red/white to redInstall the Lights Attach the Emergency Release Rope and HandleElectrical Requirements Install The Protector System Important Information about the Safety Reversing SensorWall installation Installing the BracketsGarage door track installation preferred Floor installation FigureTroubleshooting the Safety Reversing Mounting and Wiring the Safety Reversing SensorsAligning the Safety Reversing Sensors SensorsWill not need the door bracket proceed to Installation Step Fasten the Door BracketSectional Doors ONE-PIECEDOORS Connect Door Arm to Trolley Sectional Doors onlyAssemble the door arm, Figure Adjustment procedures, FigureALL ONE-PIECE Doors Connect the door arm to the trolleyIf door does not open at least 5 feet 1.5 m Adjustment StepAdjust the UP and Down Travel Limits If the door does not close completelyTest the Down close force Adjust the ForceHOW and When to Adjust the Forces Test the UP open forceImportant Safety Check Test the Safety Reversal SystemAdjust Test The Protector SystemReadand Followall Warningsand Instructions Using Your Garage Door OpenerOperation Activate your opener with any of the followingTo Open the Door Manually Using the Wall.Mounted Door ControlFeature Motion Detecting ControlRemote Control Battery Limit and Force AdjustmentsMaintenance Schedule Care of Your OpenerHaving a PROBLEM? Refer to Adjustment , Adjust the ForceSymptom LED is not fit on door control Symptom Motor unit doesnt operateTo Add or Reprogram Hand.held Remote Control ProgrammingTo Erase All Codes From Motor Function Remotes Unit Memory To Add, Reprogram or Change a Keyless Entry PIN To change an existing, known PINTo set a temporary PIN Installation Parts Repair PartsRail Assembly Parts KEY Part NO. noMotor Unit Assembly Parts DescriptionParts & Service AccessoriesWarranty Available Only Through SearsContenido Preparaci6n de la puerta de su cochera Herramientas necesariasPlanificaci6n Instalacion CON UNA Puerta SeccionalPuerta DE UNA Sola Pieza SIN Carril Planificaci6n continbaInstalacion CON Puertas DE UNA Sola Pieza Puerta DE UNA Pieza CON CarrilInventario de la caja de cart6n SECURITY.,IInventario de piezas Tornillera Y Piezas Para EL MontajeTornillera Y Piezas Para LA Instalacion MONTAJE, Paso Monte el riel e instale el troleFije el riel a la unidad del motor Instale la polea IocaInstale la banda y sujete el retn de la Cubierta de la banda Instalacion Fije la tensibn de la bandaYa termino de armar su abridor de puerta de cochera. Lea INSTALACION, Paso Determine dbnde va a instalar la m6nsula Del cabezalInstale la m6nsula del cabezal Instalacion DE LA Mensula DEL Cabezal EN EL Cielo RasoColoque el riel en la m6nsula del cabezal Coloque el abridor en posici6n Puerta DE UNA Sola Pieza SIN CarrilCuelgue el abridor No se incluyenInstalacion Paso Instale Unidad Control PuertaIiiiiiiiiiiiiiiiiiii Instale las luces Coloque la manija y la cuerda De emergenciaRequisitos para la instalaci6n el6ctrica Cableado PermanenteDelsco, 6 u,g o, ,so Instale la Sistema de Protecci6nInstalacion DE LAS M#NSULAS Inetalacion en la pared Figura 2 yInstalacion en el pieo Figura Como Alinear LOS Sensores DE Seguridad DE Reversa Fije la mnsula de la puerta Puertas SeccionalesPuertas DE UNA Sola Pieza Conecte el brazo de la puerta al trole Solo Para Puertas SeccionalesTodas LAS Puertas DE UNA Sola Pieza Arme el brazo de la puerta, FiguraAJUSTES, Paso Ajuste el limite del recorrido Hacia Arriba y Hacia AbajoComo Y Cuando Ajustar LOS Lmites Ajuste la fuerza Pruebe la fuerza del recorrido HAClA Abajo cerrarPruebe la Sistema de Protecci6n Pruebe el sistema de retroceso de seguridadPrueba C6mo Usar su Abridor de Puerta de Cochera ConserveestasinstruccionesOperacion Active su abridor de alguna de las siguientes manerasLA Consola DE Control DE Deteccion DE Movienmento C6mo usar la unidad de control de paredC6mo abrir la puerta manualmente Como Desconectar EL TroleCalendario DE Mantenimiento Mantenimiento DE SU Abridor DE Puerta DE CocheraLA Bateria DEL Control Remoto Ajustes DE Limite Y Fuerza Una vez al ruesSI Tiene Algon Problema El control remoto no activa la puertaDe reversa no Sfntoma Una o ambasDe los Sensores El circuito de los sensoresComo Programar EL Abridor C6mo agregar o reprogramar Un control remoto ManualControles remotos de 3 funciones C6mo Agregar, reprogramar Un c6digo de entrada Sin IlaveSolo estan disponibles a traves de GarantjaAccesorios Refacciones Servicio SearsYour Home

139.53915D specifications

The Sears 139.53915D is a significant addition to the lineup of garage door openers, blending both functionality and modern technology to enhance user convenience. This model is designed to accommodate residential garage doors, forming a reliable solution for homeowners who prioritize safety, security, and ease of use.

One of the standout features of the 139.53915D is its powerful motor, capable of handling heavy garage doors with ease. With its 1/2 horsepower motor, it ensures a smooth and swift opening and closing mechanism, allowing for quick access while still maintaining durability. This strength is particularly beneficial for larger or heavier doors that require more power for reliable operation.

The opener utilizes a chain drive system, renowned for its durability and strength. Chain drive systems are highly effective in providing reliable performance, making them a popular choice for various households. Despite this robust mechanism, the opener remains relatively quiet during operation, minimizing disruptions in the home environment.

A key characteristic of the Sears 139.53915D is its security features. It is equipped with rolling code technology, which generates a new code every time the remote control is used. This significantly enhances security by preventing unauthorized access and ensuring that only designated users can operate the garage door.

Additionally, the model features a safety reverse system, which automatically reverses the door's direction if it encounters an obstruction while closing. This not only protects vehicles and other possessions but also safeguards pets and children—an essential component for family households.

Installation of the Sears 139.53915D is designed to be straightforward, with comprehensive instructions that facilitate an efficient setup process. For those who prefer a seamless experience, the opener is compatible with several accessories, including smart home technologies. This compatibility allows users to integrate their garage door opener into a broader home automation system, providing added convenience and control through smartphone apps or smart devices.

In summary, the Sears 139.53915D garage door opener is a robust, reliable choice for homeowners seeking an efficient and secure opening mechanism. Its combination of a powerful motor, durable chain drive system, advanced security features, and ease of installation make it a formidable option in the market for garage door solutions.
Top Page Image Contents