Using the Wall.Mounted Door Control
THE MOTION DETECTING CONTROL
CONSOLE
Press the push bar to open or close the |
| |||
door. Press again to reverse the door | Push | |||
during the closing cycle or to stop the | Bar | |||
door | while it'sopening. |
| ||
| Lock | |||
This door control contains a motion | ||||
Bu_on | ||||
detector that will automatically | turn on | |||
Light | ||||
the light when it detects a person | Button | |||
entering the garage. This feature can be | ||||
| ||||
easily | turned off for extended | work light | use. | |
Light | feature |
|
|
To Open the Door Manually
To prevent possible SERIOUSINJURYor DEATHfrom a falling garage door:
•If possible, use emergency releasehandle to disengage trolley ONLYwhen garage door is CLOSED.Weakor broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly.
•NEVERuse emergency releasehandle unless garage doorway is clear of persons and obstructions.
•NEVERuse handleto pull door open or closed. If rope knot becomes untied,you could fall.
Press the Light button to turn the opener light on or off. It will not control the opener lights when the door is in motion. If you turn it on and then activate the opener, the light will remain on for
DISCONNECT THE TROLLEY:
The door should be fully closed if possible. Pull down on the emergency release handle (so that the trolley release arm snaps into a vertical position) and lift the door manually. The lockout feature prevents the trolley from reconnecting automatically, and the door can be raised and lowered manually as often as necessary.
Trolley | ...J |
Release Arm
(in Manual
Disconnect
Position)
Lock feature
Designed to prevent operation of the door from
To activate, press and hold the Lock button for 2 seconds. The push button light will flash as long as the Lock feature is on.
To turn off, press and hold the Lock button again for
2 seconds. The push button light will stop flashing. The Lock feature will also turn off whenever the "learn" button
on the motor unit panel is activated.
TO RE-CONNECT THE
TROLLEY:
Pull the emergency release handle toward the opener at an angle so that the trolley release arm is horizontal. The trolley will reconnect on the next UP or DOWN operation, either
manually or by using the door control or remote.
Lockout position
(Manual disconnect)
Trolley
I
i | i | i_1,, | , |
Trolley
Release
_, X Arm
Emergency "'_
Release Handle _ "%,.._
Additional feature when used with the
To control the opener lights:
In addition to operating the door, you may program the remote to operate the lights.
1.With the door closed, press and hold a small remote button that you want to control the light.
2.Press and hold the Light button on the door control.
3.While holding the Light button, press and hold the Lock button on the door control.
4.After the opener lights flash, release all buttons.
(Down and Back) "'"_,_,.[_'
To reconnect
31