Dirt Devil Y05 manual Switching off Transportation and storage, Changing the dust filter bag

POPSTER.book Seite 11 Freitag, 6. Mai 2011 1:32 13

2 Operation

2.3Switching off

12

2.4Transportation and storage

13

1.Switch off the cylinder vacuum cleaner with the on/off switch (Fig. 12/1) and pull the plug from the mains socket.

2.Keep the plug in your hand.

WARNING:

Danger of injury! During uncontrolled retraction the power cord can whip around, become an obstacle or overthrow objects. Therefore keep the plug in your hand and guide it during retraction of the power cord.

3. Push the cord retracting button (Fig. 12/2) to retract the power cord.
To transport the appliance you can carry it by the carrying-hole (Fig. 13/B1).	GB
When interrupting your work you can hang the parking-hook onto the parking bracket (Fig. 13/A).
For storing the appliance you can hook the storage hook onto the storage bracket (Fig. 13/B).
It is recommended to first retract the telescopic tube Zchapter 2.1, „Unpacking and assembling“, step 4.

ATTENTION:

Never store the appliance next to heat sources (e.g. stoves or radiators). Avoid exposing it to direct sunlight. Heat can damage the appliance.

Before storing it for a prolonged time remove the dust filter bag and disposeZchapter 2.5, „Changing the dust filter bag“ of it properly. Always store the appliance in a cool, dry place and out of reach of children.

2.5Changing the dust filter bag

14

15

16

ATTENTION:

Switch off the appliance before removing the dust filter bag. This will prevent dust from damaging the appliance.

Change the dust filter bag when the filter bag changing indicator (Fig. 14/1) shows "red," before prolonged storage or for re-shipment of the appliance.

Change the dust filter bag at least every three months for hygienic reasons.

1.Switch off the appliance and pull the plug from the mains socket, Zchapter 2.3, „Switching off“.

2.Open the dust compartment cover by pushing the release latch (Fig. 14/2) and then lifting the cover.

3.Lift the dust compartment cover until it locks in the highest position and remains open by itself.

NOTE:

If the dust compartment cover will not stay open by itself, we recommend to take off the suction hose. To do this, push both release buttons (Fig. 14/3) and pull the suction hose out of the intake opening.

4.Pull the dust bag holder together with the dust filter bag up and out of the appliance (Fig. 15) as shown.

NOTE:

Be careful when removing the dust filter bag so that no dust escapes.

5.Pull the full dust filter bag up and out of the dust filter bag holder (Fig. 16).

NOTE:

You can dispose of the dust filter bag with your regular domestic trash as long as it contains no waste materials prohibited in domestic trash.

6.Push the new dust filter bag into the filter bag holder as shown until it flushes exactly with the edge of the filter bag holder behind the two tabs, (Fig. 16, arrows).

7.Remove any dust that may have collected in the dust compartment.

8.Also check the dual motor protection filter on this occasion. Change it if necessary, Zchapter 3.3, „Cleaning the motor protection filter“.

9.Put the dust bag holder with the new dust filter bag back into the appliance:

-Do this by inserting the dust bag holder into the respective guide-rails (Fig. 17/arrows).

-Then push the dust bag holder down until it lies securely on its guide.

NOTE:

The dust chamber cover can only be closed if the dust filter bag is correctly fitted.

10.Close the dust compartment cover. It snaps shut.

17

11