Emerson 00825-0100-4530 Rev EC manual Remote housing, continued

March 2013 Quick Installation Guide

Step 2 continued...

M50 nut

U-bolt Bracket Clamping brackets

M6 screw

Remote housing

1.Remove the transmitter head from the probe by unscrewing the M50 nut.

For safety information regarding ESD discharge, see the applicable warning on page 3.

2.Mount the probe in the tank.

3.Mount the bracket to the pole, making sure the distance between the probe and bracket does not exceed the length of the remote connection.

Put the two U-bolts through the holes of the bracket. Several holes are available for vertical/horizontal pipe mounting.

Put the clamping brackets on the U-bolts and around the pipe.

Use the supplied nuts to fasten the bracket to the pipe.

4.Fasten the housing support to the bracket using the M6 screws. The screws are threaded through the top of the mounting bracket and into the housing support.

M50 nut

5. Mount the probe housing on the probe, making sure that the M50 nut is properly tightened.

6. Connect the transmitter head on the housing support, making sure that the M50 nut is properly tightened.

7