Timer
The Timer can be set in minutes and seconds or hours and minutes and counts down the set time.
NOTE: The Timer does not start or stop the oven.
1.Press TIMER SET/START.
Press again to switch from MIN/SEC and HR/MIN.
2.Press the number pads to set length of time.
3.Press TIMER SET/START to start the timer.
When the set time ends, timer completion tones will sound, then reminder tones will sound approximately every
10 seconds.
4.Press TIMER OFF anytime to cancel the Timer and/or stop reminder tones.
If OFF is pressed, the oven will turn off.
The time can be reset during the countdown by repeating the above steps.
OPTIONS
OptionsSelection Pad
The OPTIONS selection pad allows you to access special functions within the Electronic Oven Control that allow you to customize the product to your needs. These special functions allow you to change the oven temperature between Fahrenheit and Celsius, turn the audible signals and prompts on and off, and adjust the oven calibration. The Dehydrate and Sabbath Mode are also set using the OPTIONS selection pad.
To Use:
Press OPTIONS. The oven display will scroll through the various options, starting at 1 and ending in 7. You can also press the OPTIONS selection pad and number pad to quickly enter the desired hidden function.
OPTIONS | SPECIAL FUNCTION |
1 | Fahrenheit and Celsius conversion |
2 | Tones On/Off |
3 | Tones High/Low |
4 | Cooking Time Completion Tones On/Off |
5 | Dehydrate |
6 | Oven temperature calibration |
7 | Sabbath Mode |
Fahrenheitand Celsius- Option 1
Fahrenheit is the default setting, but setting may be changed to Celsius.
To Change: Press OPTIONS, then 1 on the keypad for Celsius. To convert back to Fahrenheit, press OPTIONS, then 1 again on the keypad.
Timer Completion Tones
Three chimes sound when the timer reaches zero. This can occur when using the timer for functions other than cooking.
Cooking Time Completion Tones
Three beeps indicate the end of a cooking cycle.
All Tones ON/OFF
All tones are preset to ON, but can be turned OFF.
To change: Press OPTIONS, then 2 to turn tones OFF. To turn tones ON, press OPTIONS again, and then 2.
Tone Volume High/Low
The volume is preset to HIGH, but can be changed to LOW.
To change: Press OPTIONS, then 3 for LOW. Press OPTIONS, then 3 again for HIGH.
Cooking Time Completion Tones ON/OFF
All tones are preset to ON, but can be turned OFF.
To change: Press OPTIONS, then 4 to turn tones OFF. To turn tones ON, press OPTIONS again, and then 4.
Dehydrate - Option 5
(on convection models, closed door)
Dehydration is a method used to preserve food. Various factors, such as the quality of the fresh food, pretreatment techniques, the size and thickness of the food, and the climate may affect the finished product.
During dehydration, heat is used to force out moisture and air circulation is used to carry the moisture away.
Refer to a reliable book or source for complete information about dehydrating and preserving foods.
Tones- Options 2, 3, 4
Tones are audible signals, indicating the following:
One beep
■Function has been entered
Three beeps
■Invalid pad press
Preheat Completion Tone
One chime indicates a preheat cycle has been completed.
To Dehydrate:
Position the racks according to the following chart. See “Positioning Racks and Bakeware” section for diagram.
NUMBER OF RACKS | RACK POSITION(S) |
1 | 3 |
|
|
2 | 2 and 4 |
|
|
3 | 1, 3 and 5 |
|
|
12