English
ESpout
FClamp
GDriving shaft
HJuice jug with removable foam separator and lid
ICord storage compartment
JControl knob
KPulp container
Getting started
Preparing the juicer
1Clean all detachable parts (see chapter ‘Cleaning’).
2Pull the mains cord out of the cord storage compartment at the back of the appliance.
3Snap the spout onto the juice collector (Fig. 2).
4Place the juice collector onto the appliance and put the filter in the juice collector. Make sure the filter is fitted securely onto the driving shaft (Fig. 3).
Always check the filter before use. If you detect any cracks or damage, do not use the appliance. Contact the nearest Philips service centre or take the appliance to your dealer.
5Push the pulp container against the appliance (‘click’) and put the lid on the appliance. (Fig. 4)
6Snap the two clamps onto the lid (‘click’). Slide the pusher into the feeding tube. (Fig. 5) Make sure the clamps on either side of the lid are locked into position.
7Place the juice jug under the spout (Fig. 6).
The juice jug has a removable foam separator.The foam separator removes the foam from the juice when you pour the juice into a glass.
Tip:To keep your juice fresh longer, put the cover on the juice jug after juicing.
Using the juicer
The appliance only works when all parts are properly assembled and the lid is properly locked in place with the clamps.
Do not operate the juicer for more than 40 seconds at a time when you process a heavy load. Let the appliance cool down before you continue.
1
2
3
-
-
Wash the fruit and/or vegetables and cut them into pieces that fit into the feeding tube. Make sure the spout is attached to the juice collector and the juice jug is under the spout.
Turn the control knob to setting 1 (low speed) or 2 (normal speed).
Speed 1 is especially suitable for soft fruits and vegetables such as watermelons, grapes, tomatoes and cucumbers.
Speed 2 is suitable for all other kinds of fruit and vegetables such as apples, carrots and beetroots.
4Put the fruit and/or vegetables in the feeding tube and gently press them down towards the rotating filter with the pusher.
Do not exert too much pressure on the pusher, as this could affect the quality of the end result. It could even cause the filter to come to a halt.
Never insert your fingers or an object into the feeding tube.
5If the pulp container becomes full during use, switch off the appliance, carefully remove the pulp container and empty it.