TROUBLESHOOTING
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call.
In the U.S.A., www.maytag.com In Canada, www.maytag.ca
Ice Maker Operation
Your ice maker will not operate
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
■Is the power cord plugged in? Plug into a grounded 3 prong outlet.
■Is the control set to ON? Be sure that the control is set to ON.
■Has a household fuse blown, or has a circuit breaker tripped? Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.
■Is the room temperature cooler than normal? Room temperature must be above 55°F (13°C). Otherwise, bin thermostat may sense cold room temperature and shut off even though the bin is not full of ice. Also, unit may not restart once it does shut off.
■Does the green light come on when the Clean button is pushed? The ice maker is receiving power but may need cleaning. See “Cleaning.”
■Does the ice maker have a drain pump? If there was a large amount of water added to the ice maker, wait a few minutes for the drain pump to clear. If there is still water in the bin, check to see whether the drain hose is kinked.
Ice maker seems noisy
■Is water being circulated through the ice maker? This is normal operation. Water is added once per
■Is the water in the reservoir overflowing? This is normal. This overflow helps to purge minerals that were removed from the water during the ice making process.
■Is there a “whooshing” sound? Check the following things:
■Make sure that the water supply is hooked up and turned on.
■Make sure that the drain cap is tight and the water drain pan pump is securely attached to the water pan.
■Is there ice between the evaporator plate and the cutting grid? Check that the ice maker is level. See “Leveling.” If the ice maker is level, and the problem persists, run a cleaning cycle. See “Cleaning.”
Ice Production
Ice maker runs but produces no ice
■Is the control set to ON? Be sure that the control is set to ON.
■Is the water supply connected? Make sure the water supply is properly connected and turned on.
■Is the drain cap securely in place? If the drain cap is loose, water will empty from the water pan, and you will have either thin ice or no ice. Tighten the drain cap.
■Is there debris in the drain tube? Clean the drain tube.
■Is there a kink in the drain line? Be sure that there are no kinks in the line.
■Is the service light flashing on and off continually? Call for service.
11