Optional Control Settings
The controller display has several options and features.
SYSTEM/ELECTRONIC DIAGNOSTICS |
|
This display contains system diagnostics |
|
information to assist in troubleshooting |
|
problems with the Water Softener. See | OR |
page 15. |
|
To access the System Diagnostics, press and hold the MODE button for 3 seconds.
To return to the normal display, press the MODE button 2 times.
SALT EFFICIENCY
When the SALT EFFICIENCY feature is ON, the unit will operate at a salt efficiency of at least 4000 grains of hardness removed per pound of salt. This mode of operation is the most efficient setting for salt usage, because the system will tend to recharge more often, with less salt usage. Turning the feature OFF will tend to lengthen the time between recharge cycles, which will provide the most efficient usage of water, but may use more salt. The degree of difference between these two cycles is highly dependent on the water usage and hardness at a particular installation.
NOTE: California Regulations require this feature to be ON for installations in California.
ERROR SIGNALS | DAYS TO EMPTY |
If there is an error code detected, the display |
|
will flash Err to signal that the softener | HARDNESS |
requires service. |
|
See page 14 for information to assist in troubleshooting error codes. Once the problem is corrected, disconnect the transformer from the wall outlet momentarily, and plug it back in. The normal display will appear. The motor may run for several minutes, as the unit resets. If the problem is not corrected, the error code will reappear in 6 minutes.
To access the Salt Efficiency, press and hold the MODE button for 3 seconds. The System Diagnostics display will appear.
Press the MODE button again and the Salt Efficiency display will appear.
To change the setting, press the UP 
or DOWN 
buttons to toggle the feature ON or OFF. Press the MODE button to accept.
DAYS TO EMPTY | E |
HARDNESS |
|
DAYS TO EMPTY | E |
HARDNESS |
|
9