Haier DW-7777-01 manual Water, Drain, You must have, English

English

Water

You must have

•A hot water line with 20-120 psi (138-862 kPa) water pressure.

•Inlet water temperature 120º F(49º C) minimum at the dishwasher is recommended.

•3/8” (0.9cm) O.D. tubing with compression fitting or flexible stainless steel braided fill line (1/2” (1.3cm) minimum plastic tubing is optional but not recommended).

• A 90º elbow with 3/8” (0.9cm) N.P.T. external pipe threads on one end. Do not solder within 6”(15.2cm) from water inlet valve.

DRAIN

You must have

• Use the new drain hose supplied with your dishwasher. If this is not suitable, use a new drain hose with a maximum length of 12 feet (3.7m) that meets all current AHAM / IAPMO test standards, is resistant to heat and detergent, and fits the drain connector on your dishwasher.

• Have a high drain loop 30 inches (76.2cm) above the subfloor or floor.

• Connect drain hose to waste tee or disposer inlet above drain trap in house plumbing and 20 inches (50.8cm) minimum above the floor.

•Use an air gap in the drain line if the drain hose is connected to house plumbing lower than 20 inches (50.8cm) above subfloor or floor.

•Use 1/2” (1.3cm) minimum I.D. drain line fittings.

9