English
Check Operation
1.Read the Use and Care Guard included with your dishwasher.
2.Check that all parts have been installed and no steps were skipped. Check that you have all the tools you used.
3.At fuse box or circuit breaker, turn on electrical power supply to dishwasher.
Start dishwasher and allow it to complete the shortest wash cycle. After the first two minutes, unlatch door, wait five
seconds, then open door. Check to see that
there is water in the bottom of the dishwasher and that there are no water leaks.
4. Check that grounding clip “A” is attached to the lower panel. Place the lower panel “B” behind the access panel “C”. Some models have insulation “D” on the access panel which must fall behind the insulation “E” on the lower panel. Hold the two panels together and place them against dishwasher leg.
Reinstall the screws through the holes in the access panel and the slots in the lower panel. Install right side screw first. Check that the lower edge of the lower panel contacts the floor. Tighten the screws.
If dishwasher does not operate:
• Has the circuit breaker tripped or the house fuse blown?
•Is the door closed tightly and latched?
•Has the cycle been set correctly to start the dishwasher?
•Is the water turned on?
25