Haier DW-7777-01 34” 86.4 cm, 34 1/4” 87 cm, 34 1/2” 87.6 cm, Min Cutout, Wheel Position, Height

English

HELPFUL TIP:

Put cardboard under dishwasher until it is installed. The cardboard

will help protect floor during installation.

4. Remove terminal box cover “H”. Pull	H
appliance wires “I” through hole in terminal
box. Do not untie the knot in the wires.
If you are direct wiring: install a UL-listed/
CSA-certified clamp connector “J” to	I
the terminal box. If using conduit use a
UL-listed/CSA certified conduit connector. If	J
you are installing a power supply cord kit,
do so now and follow kit instructions.

5. Measure height of cabinet opening from underside of countertop to floor where

K

dishwasher will be installed “K” (you need the lowest point). Check chart for that height opening. Put wheels “L” in the required position. Turn both front leveler legs to the same height.

Min Cutout	Wheel Position	Number of Turns
Height	(See Illustration)	on Front Leg
34” (86.4 cm)	1	10
34 1/4” (87 cm)	2	5
34 1/2” (87.6 cm)	3	0

If the minimum cutout height is less than 34” (86.4 cm), the adjustable legs can be removed for additional clearance. This will allow the dishwasher to fit into a 33 4/5” (85.9 cm) high cutout, but the dishwasher will be more difficult to move into position. If the wheels are removed, protect the floor when moving the dishwasher.

16