4.Remove 2 screws from the bake burner.
5.Slide the front of the bake burner to the side to remove tab from front of oven. Lift the back of the bake burner off the oven orifice, and set the bake burner aside. Do not disconnect the wire.
A
B
10.Position the front of the oven bottom panel toward the front frame, and then lower the rear of the oven bottom panel into the oven.
11.Reattach the oven bottom panel with 2 screws and 2 washers.
To Convert Oven Broil Burner (LP Gas to Natural Gas)
1.Remove 1 screw from the broil burner.
2.Remove the flame spreader.
3.Remove the broil burner from the broil burner orifice hood.
NOTE: The broil burner will hang in the back of the oven while you are changing the orifice hood.
A. Bake burner
B. Screws
A
A. Oven orifice
6.Apply masking tape to the end of a ³⁄₈" (1 cm) nut driver to help hold the gas orifice spud in the nut driver while changing it. Press nut driver down onto the gas orifice spud and remove by turning the LP gas bake burner orifice spud counterclockwise to remove. The spud will be stamped with a “56.”
7.Replace the “56” spud with a “47” spud. Install the Natural gas bake burner orifice spud, turning it clockwise until snug.
IMPORTANT: Do not overtighten.
A
A. Orifice spud
8.Position the back of the bake burner over the oven orifice, and then align the holes for the screws.
9.Reattach the bake burner with 2 screws.
A
C
B
D
A. Broil burner
B. Flame spreader
C.Screws
D.Orifice hood
4.Apply masking tape to the end of a ³⁄₈" (1 cm) nut driver to help hold the gas orifice spud in the nut driver while changing it. Press nut driver down onto the gas orifice spud and remove by turning the LP gas broil burner orifice hood counterclockwise to remove. The hood will be stamped with a “100.”
5.Replace the “100” hood with a “155” hood. Install the Natural gas broiler burner orifice hood, turning it clockwise until snug.
IMPORTANT: Do not overtighten.
A
A. Orifice hood
6.Place the broil burner on the broil burner orifice hood. Insert the broil burner ceramic igniter in the hole in the rear of the oven.
7.Replace the flame spreader with all 4 tabs facing up and the notches toward the rear of the oven.
8.Position the broil burner against the top of the oven and attach it with 1 screw.
21