Whirlpool W10665256D Remove/Replace Drawer, Oven Door, Check Operation of Oven Broil Burner

Repeat steps 1 to 3. If the burner does not light at this point, press the off pad and contact your dealer or authorized service company for assistance. Please reference the “Warranty” section of the User Guide to contact service

If the bake burner flame needs to be adjusted, see the “Adjust Flame Height” section.

Refer to the User Guide for proper operation of the oven controls.

Check Operation of Oven Broil Burner

1.Close the oven door.

2.Press BROIL.

3.Press the Start pad.

The oven burner should light within 8 seconds. The first time a burner is lit, it may take longer than 8 seconds to light because of air in the gas line.

4.After 2 minutes, open the oven door and check that the oven is warm.

If Burner Does Not Light Properly:

■Press the Off pad.

■Check that the range is plugged into a grounded 3 prong outlet. Check that the circuit breaker has not tripped or the household fuse has not blown.

■Check that the gas shutoff valves are set to the open position.

Repeat steps 1 to 3. If the burner does not light at this point, press the off pad and contact your dealer or authorized service company for assistance. Please reference the “Warranty” section of the User Guide to contact service

If the broil burner flame needs to be adjusted, see the “Adjust Flame Height” section.

Refer to the User Guide for proper operation of the oven controls.

Remove/Replace Drawer

(on some models)

Remove all items from inside the baking drawer, warming drawer or premium storage drawer, and then allow the range to cool completely before attempting to remove the drawer.

To Remove:

1.Open the drawer to its fully open position.

2.Using a flat-blade screwdriver, gently loosen the drawer from the glide alignment notch, and then lift up the drawer alignment tab from the glide.

A

B

C

A.Flat-blade screwdriver

B.Drawer alignment tab

C.Drawer glide notch

3.Repeat Step 2 on the other side. The drawer is no longer attached to the drawer glides. Using both hands, pick up the drawer to complete the removal.

To Replace:

1.Align the forward drawer notches with the notches in the drawer glides on both sides. Place the rear alignment tabs into the drawer glides on both sides.

A

B

A. Drawer alignment tab

B. Drawer glide notch

2.Push the drawer in all the way.

3.Gently open and close the drawer to ensure it is seated properly on the glides on both sides.

Oven Door

For normal range use, it is not suggested to remove the oven door. However, if removal is necessary, make sure the oven is off and cool. Then, follow these instructions. The oven door is heavy.

To Remove:

1.Open oven door all the way.

2.Pinch the hinge latch between two fingers and pull forward. Repeat on other side of oven door.

A

A. Hinge latch

3.Close the oven door as far as it will shut.

4.Lift the oven door while holding both sides.

Continue to push the oven door closed and pull it away from the oven door frame.

14