Door Removal Instructions
DOOR REMOVAL INSTRUCTIONS:
If it is necessary to move the refrigerator through narrow doorways, follow these steps to remove the doors.
IMPORTANT: Before you begin, turn freezer temperature control to OFF and remove electrical power cord from wall outlet. Remove any food from door shelves.
1.Disconnect electrical supply.
2.Open both doors, then remove toe grille.
3.Close doors.
To Remove Refrigerator Door:
1.Remove top hinge cover screw on refrigerator door and remove cover.
2.Trace around hinge with soft lead pencil. This will make it easier to realign doors when they are replaced.
3.Remove top hinge and lift refrigerator door off bottom hinge pin. Set door aside.
4.Remove bottom hinge, if necessary.
5. Reverse this procedure to reinstall refrigerator door.
To Remove Freezer Door:
1. Disconnect water line coming from lower hinge of freezer door at connection located under front of freezer: grip water tube firmly in one hand, then with 3/8” wrench or fingers, push in on gray collar to release water connector.
2.Remove top hinge cover screw on freezer door and remove cover.
3.Disconnect wiring harness connector plug at top hinge: place your thumbs on flat sides of each connector and bend both parts back and forth, then with firm grasp, pull both pieces apart.
4.Trace around hinge with soft lead pencil. This will make it easier to
realign doors when they are replaced.
5. Remove top hinge,allowing wiring harness to pull through hinge and lift freezer door off of bottom hinge pin. Lay door down flat to avoid kinking water line.
6. Remove bottom hinge, if necessary.
7. Reverse this procedure to reinstall freezer door.
When both doors have been reinstalled, replace toe grille and plug in electrical power cord. Turn both temperature controls to center position. Adjust settings as necessary.
6