Kenmore 665.75839, 665.75837 Sealed Surface Burners and Cooktop contd, Removing the Oven Door

SEALED SURFACE BURNERS AND COOKTOP (contd.)

I".cleantheburners:o

1.Remove the burner cap from the burner base.

2, Clean the burner cap with warm, soapy water

and a sponge. You can also clean it with a mildly abrasive scrubbing pad or cleanser.

Do not clean the burner cap in a dishwasher or self-cleaning oven.

3.If the gas tube opening has become soiled or clogged, use a damp cloth to clean the area.

4.ff the burner ports are clogged, clean them

fwith a straight pin. Do not enlarge or

distort the port. Do not use a wooden

toothpick. If the burner needs to be

adjusted, call a qualified technician for service.

5.After cleaning the gas tube opening and ports,

O	replace the burner
	cap. To replace the
	burner cap, make
	sure the alignment

@properly aligned with the burner base.pins on the cap are

Gas tube opening

6.Turn on the burner to see if it will light. If the

after you have cleaned it, recheck cap alignment

or contact a Sears

i_burner does not light Service Center. Do not

service the sealed

burner yourself.

REMOVING THE OVEN DOOR

For normal use of your range,	you do	not	need to	Door removal	Door stop clip
remove the door. However, if you find		it necessary		pin hole
to remove the door, follow the	instructions		in this	_
section.

NOTE: The oven door is heavy.

Before removing the door:

1.Use a putty knife or screwdriver and insert it at the bottom corner of the door stop clip.

2.Pry door stop clip free and remove from front frame hinge slot. Take care not to scratch porcelain.

3.Repeat procedure for other door stop clip.

Hinge Front frame

hanger hinge slot

34