Kenmore 318205869A manual Self-Clean Time Length, Adjusting the Oven Temperature

Page 20

Self-Cleaning

Self-Clean Time Length

For satisfactory results, use a 2 hour Self-Clean cycle for light soils and a 3 hour cycle for average or a 4 hour cycle for heavy soils. NOTE: The kitchen area should be well ventilated using an open window, ventilation fan or exhaust hood during the Self-Clean cycle. This will help eliminate the normal odors associated with the Self-Clean cycle.

To Set the Controls for a Self-Clean Cycle or a Delayed Start Self-Clean Cycle:

(Note: If you do not want to start a Delayed Self-Clean Cycle, skips steps 2 & 3.)

1.Be sure the clock shows the correct time of day.

2.Press . The “ : “ in the time of day will flash.

3.Press and hold the pad to scroll to the time to start the delayed Self-Clean cycle. Release the pad when the desired time is displayed.

4.Press . “— — —” appears in the display.

5.Press the or once. “3:00” appears in the display for a 3 hour cycle. To change to a 2 hour cycle press . “2:00” appears in the display or to select a 4 hour cycle press . “4:00” appears in the display.

As soon as the controls are set, the motor driven lock will begin to close automatically and the “DOOR LOCK” indicator light will flash. DO NOT open the oven door while the light is flashing (it takes about 15 seconds for the oven door to lock).

6.“CLn” will appear in the display during the Self-Clean cycle and the “DOOR LOCK” light will glow until the Self- Cleaning cycle is complete or cancelled and the oven temperature has cooled.

When the Self-Clean Cycle is Completed:

1.The time of day or “End” will appear in the display window and the “Clean” and “DOOR LOCK” light will continue to glow.

2.Once the oven has cooled down for about 1 HOUR and the “DOOR LOCK” light has gone out, the oven door can be opened.

3.If “End” is in the display and the Select Clean indicator light remains ON, press . The time of day will appear in the

display.

NOTE: When the oven is cool, wipe away any residue or powdered ash with a damp cloth or paper towel.

Stopping or Interrupting a Self-Cleaning Cycle:

If it becomes necessary to stop or interrupt a Self-Cleaning cycle:

1.Press .

2.Once the oven has cooled down for about 1 HOUR and the “DOOR LOCK” light has gone out, the oven door can be opened.

3.Restart the Self-Clean cycle once all conditions have been corrected.

To avoid possible burns use care when opening the oven door after the Self-Cleaning cycle. Stand to the side of the oven when opening the door to allow hot air or steam to escape.

DO NOT force the oven door open. This can damage the automatic door locking system. Use caution and avoid possible burns when opening the door after the Self-Cleaning cycle has completed. The oven may still be VERY HOT.

Adjusting the Oven Temperature

Your oven control has been precisely set at the factory. This setting may differ from your previous oven however, so your recipe times may not give you the results you expect. If you think that the oven is cooking too hot or too cool for your recipe times, you can adjust the control so that the oven cooks hotter or cooler than the temperature displayed.

To Adjust Oven Temperature:

1.Press .

2.Set the temperature to 550°F (287°C) by pressing and holding the .

3.Within 2 seconds, press and hold until the 2 digit display appears. Release . The display now indicates the amount of degrees offset between the original factory temperature setting and the current temperature setting. If the oven control has the original factory calibration, the display will read "0."

4.The temperature can now be adjusted up or down 35°F or 19°C, in 5°F or 1°C steps by pressing and holding the or . Adjust until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign

(-) will appear before the number to indicate that the oven will be cooler by the displayed amount of degrees.

5.When you have made the desired adjustment, press to go back to the time of day display.

Note: Oven temperature adjustments made will not change the Self-Cleaning feature temperature.

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Kenmore Table of Contents Important Safety Instructions Where appliance is in use. They should never While using the appliance. Do not let clothingWhen heating fat or grease, watch it closely Do not leave children alone-Children shouldSave These Safety Instructions Grounding Instructions Conversion to Liquefied Petroleum Gas or L.P. GasSlide-in Range Features Your Slide-in Range Features At a GlanceBefore Setting Surface Controls Control Locations of the Gas Surface BurnersSetting Surface Controls Setting Proper Surface Burner Flame SizeOperating the Gas Surface Controls Flame Size Type of CooktopUse Proper Cookware Using a wokSurface Cooking Before Setting Oven Controls Oven Vent LocationRemoving and Replacing Oven Racks Arranging Oven RacksSetting Oven Controls Control Pad FunctionsTo Set the Minute Timer Temperature conversionTo Change the Minute Timer while it is in use To Set the ClockTo Set Control for Oven Lockout To Set or Change the Temperature for BakingTo Set Control for Continuous Bake or 12 Hour Energy Saving Cooking Information Oven BakingTo Set the Timed Bake and Delay Start Features When the Set Bake Time Runs OutSetting Oven Controls cont’d To Set for Broiling Broil Rack Position Table Refer to Fig Food categorySetting the Warm & Hold Feature To Operate the Oven LightTo set Warm & Hold To set Warm & Hold to turn on automaticallySelf-Cleaning Oven CleaningTo Adjust Oven Temperature Self-Clean Time LengthAdjusting the Oven Temperature General Care & Cleaning Cleaning Various Parts of Your Range3rd General Care & Cleaning cont’dCleaning the Cooktop, Burner Heads, Caps & Grates Removing and Replacing the Lift-Off Oven Door Door Hinge locations With oven door fully openTo Remove Oven Door To Replace Oven DoorChanging Oven Light Storage DrawerSolutions to Common Problems Appliance must be accessible forService Code error for exemple F11Self-cleaning cycle does not work Cleaning cyclePoor baking results Fan noise during cooking operationProtection Agreements Get it fixed, at your home or ours Cuisinière encastrable Emplacementdelaplaque de série Table des matièresGarantie sur appareil Kenmore Enregistrement de l’appareilEntretien par l’usager-Ne réparez pas ou ne Le faites, un empoisonnement au monoxyde deCarbone pourrait en résulter et l’appareil pourrait Ne modifiez jamais l’appareil, que ce soit enMesures de sécurité importantes Fours autonettoyants Ne laissez jamais les brûleurs sans surveillanceInstructions de mise à la terre Conversion au gaz propaneCaractéristiques de l’appareil Four autonettoyantAvant de régler les commandes des brûleurs de surface Emplacement des commandes des brûleurs de surfaceRéglage des commandes des brûleurs de surface Réglage de la bonne dimension de la flammeEmploi des brûleurs de surface Type de cuissonUtilisation d’UN wok Cuisson sur la table de cuissonUstensiles pour la cuisson sur les brûleurs Avant de régler les commandes du four suite Installation des grillesPosition de l’évent Enlever et replacer les grilles de fourRéglage de la commande du four Fonctions des touches de la commande du fourPour un tableau de commande silencieux Réglage de lhorlogeRéglage de la minuterie Conversion de la températurePour régler la fonction de verrouillage Pour régler la commande du four pour la cuisson au fourRéglage de la fonction de verrouillage du four Cuisson au four Lorsque la durée de cuisson programmée s’est écoulée Cuisson au gril Catégorie d’alimentRéglage de la fonction Garder ChaudMD Réglage de la fonction Garder ChaudMDFonctionnement de la lampe du four Cycle autonettoyant Nettoyage du fourPrenez les précautions de nettoyage qui suivent Préparation du four avant le cycle autonettoyantDurée du cycle autonettoyant Ajustement de la température du fourLa fin du cycle autonettoyant Arrêt ou interruption d’un cycle autonettoyantEntretien général & nettoyage Entretien général & nettoyage suite 1erNettoyage de l’acier inoxydable Enlever et replacer la porte du fourPour enlever la porte du four Pour replacer la porte du fourRemplacement de l’ampoule du four Tiroir de rangementSolutions aux problèmes les plus fréquents Facilement. Il doit être accessibleLa commande du four sonne et ’appareil n’est pas de niveauLa flamme est orange Le four dégage beaucoup de fuméeDurant la cuisson au gril Tion Réglage du four AutonettoyantContrats DE Protection Get it fixed, at your home or ours
Top Page Image Contents